SEAVIEW SMADFB Adjustable Flybridge Mast Mount Adapter Instruction Manual
- June 14, 2024
- SEAVIEW
Table of Contents
INSTALLATION
INSTRUCTIONS
For Seaview Adjustable Flybridge
Mast Mount Adapter:
SMADFB
SMADFB Adjustable Flybridge Mast Mount Adapter
Refer to website for most up to
date instructions and videos.
WWW.SEAVIEWGLOBAL.COM
NOTE:
It is strongly advised that all installations are carried out by an authorized
installer who possesses the necessary expertise and experience in marine
equipment installation.
Furthermore, prior to the final installation process, we recommend performing
a dry fit assembly of allcomponents. This entails fitting the components in
their designated positions on the boat without permanently affixing them. This
step allows for careful assessment of compatibility, alignment, and any
potential adjustments that may be required before proceeding with the actual
installation.
PARTS INCLUDED
Sudbury
Elastomeric Marine Sealant is recommended.
To purchase call 800-655-7922 or visit
www.seaviewglobal.com
| 
Note: Rivet, screw or bolt depending on mounting surface.
Hardware not provided for this.
---|---
| 
| 
Note: Rivet, screw or bolt depending on mounting surface.
Hardware not provided for this.
Note: Rivet, screw or bolt
depending on mounting surface.
Hardware not provided for this.| 
| |
---|---|---
NOTE: Refer to cable gland instructions to follow| Place the plastic base onto
the rubber base gasket.
Be sure to line up the four screw holes.| Drill pilot holes and secure the
base. Apply marine adhesive sealant to the threads of the screws.
| | 
Insert the rubber tapered plug into the base.| Line up the Cable Gland cover
with the four holes in the plastic base and screw the bolts in with a 2.5mm
wrench, compressing the
rubber grommet.| Measure your cable diameter and select the appropriate drill
tube provided.
|
---|---
• Make sure that you do not drill within 1/8” (3.2mm) from the edge of the
tapered plug.
• A slightly larger drill bit is needed for drilling the rubber.| If using a
drill bit, the drill should be run repeatedly through the rubber.
|
Remove the four screws using a 2.5 mm allen wrench.| Remove the Cable Gland
cover and tapered plug.
|
Using a sharp razor blade or knife, cut the tapered plug from the cable hole
outward.| Slide the Cable Gland cover over the electronic cable.
|
Wrap the tapered plug around the electronic cable.| Insert the electronic
cable and tapered plug into the plastic base.
|
Slide the Cable Gland cover onto the plastic base making sure that all four
bolt holes line up.| Apply marine adhesive sealant to the four allen head
screws and tighten.
ELEVATE YOUR ELECTRONICS
Tel: 800-655-7922
www.seaviewglobal.com
EUROPEAN OFFICE
Tel: +33 4 94 53 27 70
www.seaviewprogress.com
6-09072023
References
- Seaview | Leaders In Mounting Solutions For Marine Electronics
- Profitez des meilleurs équipements pour votre bateau
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>