PureLink HOF T2.0 TAA Compliant 4K60 HDMI Over Fiber Optic Extension System User Manual
- June 14, 2024
- PureLink
Table of Contents
PureLink HOF T2.0 TAA Compliant 4K60 HDMI Over Fiber Optic Extension
System
PureLink
22-10 State Rt. 208 Fair Lawn, NJ 07410USA
Tel: +1.201.488.3232
Fax: +1.201.621.6118
E-mail: sales@purelinkav.com
For order support, please contact your local dealer.
For technical support, please contact us at
support@purelinkav.com
Thank You for Purchasing This Product
For optimal performance and safety, please read these instructions carefully
before connecting, operating or adjusting this product. Please keep this
manual for future reference.
Surge Protection Device Recommended
This product contains sensitive electrical components that may be damaged by
electrical spikes, surges, electric shock, lightning strikes, etc. The use of
surge protection systems is highly recommended in order to protect and extend
the life of your equipment.
Introduction
The HOF T2.0 Tx/Rx is TAA Compliant and offers a powerful solution for Ultra HD, long-distance distribution of A/V, KVM, and control signals over fiber. Ultra HD/4K HDMI 2.0 (18Gbps), embedded audio, USB, and bi-directional RS-232 and IR are all supported over distances up to 1.24 miles (2000 m.) using PureLink’s TotalWire LC-terminated fiber optic cables. The pure fiber connection provides protection from electromagnetic interference (EMI), delivering lossless transport for optimal signal quality.
Product Features
- TAA Compliant
- Supports resolutions up to 4K@60Hz 4:4:4, HDR
- Supports distances up to 1.24 miles (2000 m.) over single-mode fiber
- HDMI 2.0, HDCP 2.2 Compliant
- Real-Time Auto-EDID Management
- 18Gbps bandwidth support
- Supports LPCM 7.1 audio, Dolby TrueHD, Dolby Atmos, DTS-HD Master Audio, DTS:X formats
- Bi-directional IR & RS-232 control
- Supports USB keyboard mouse
Package Contents
- 1 x HOF T2.0 Transmitter
- 1 x HOF T2.0 Receiver
- 2 x 10G SFP+ 1.24 miles (2000 m.) single-mode optical transceiver
- 2 x DC 5V 2Amp power adapter
- 1 x IR Emitter cable
- 1 x IR Receiver cable
Specifications
Connector Type/s (Tx)
| Inputs: (1) HDMI Type A female, (1) USB Type B Outputs: (1) SFP 10G+ Fiber module
Control: (1) DB9 female [RS-232], (2) 3.5mm jack [IR Input/Output]
---|---
Connector Type/s (Rx)
| Inputs: (1) SFP 10G+ Fiber module
Outputs: (1) HDMI Type A female, (2) USB Type A
Control: (1) DB9 male [RS-232], (2) 3.5mm jack [IR Input/Output]
Resolutions| 4K@60Hz 4:4:4 18Gbps (6Gbps per color) 1080p@60Hz 16bit, 3D, HDR,
Dolby Vision
Compliance| HDMI 2.0, HDCP 2.2, HDCP 1.4
Audio Formats| LPCM 7.1 @192KHz, Dolby TrueHD, Dolby Atmos, DTS-HD Master
Audio, DTS:X
Transmission Distance| up to 1.24 miles (2000 m.) over single-mode fiber
RS-232 Data Rate| 115200 bps / Full Duplex
Power Consumption| Max 5 W
Power Supply| DC 5V 2A
Temperature| Operation: 14~113°F (-10~45°C)
Storage: -22~158°C (-30~70°C)
Relative Humidity| Up to 95%
Product Dimensions| 4.31”x4.51”x1.18” (109.6 x 114.5 x 30mm)
Product Weight| 0.6 lb. (270g)
Operation
Installation
Please note: the working distance is subject to the type of Fiber Optic cable
used and the type of transceiver used.
HOF T2.0 Transmitter Panel View
HOF T2.0 Receiver Panel View
LED Indicators
- When the Green LED is on = unit is getting power
- When the Blue LED is on = Fiber link between transmitter and receiver is connected
Dip Switch Functionality
| Switch | Function |
|---|---|
| SW 1 | ON |
Mouse Extender
Function
SW 2| OFF| ON| ON
SWITCH position 1 and 2 must be positioned as above instructed above:
IR: SW1 ON (down position) + SW2 OFF (up position)
RS232: SW1 OFF (up position) + SW2 ON (down position)
USB: SW1 ON (down position) + SW2 ON (down position)
RS232
DB9 (F)
RS232
Pin| Define
Pin 2| TX
Pin 3| RX
Pin 5| GND
DB9 (M)
RS232
Pin| Define
Pin 2| RX
Pin 3| TX
Pin 5| GND
Warranty
PureLink™ Three (3) Year Limited Warranty
- For HDTools™ & PureStream™ Branded Products Only
- Dtrovision, LLC. (hereinafter “PureLink”) warrants its HDTools™ and PureStream™ branded products (hereinafter “Product”) purchased directly from PureLink or Dealer shall be free from defects in workmanship and materials, under normal use and service, for a period of three (3) years on parts and three (3) years on labor. Any repaired or replaced equipment related to Product shall be covered only under the remaining portion of the warranty. This warranty has no relationship to and exists independently of any warranty offered by Dealer. This warranty is a limited warranty and gives you specific legal rights. You may also have other rights which vary from state to state.
TERMS & CONDITIONS
- PureLink shall repair or replace the Product if it develops a material fault during the period of warranty, on condition that i) the Product has only been subject to normal use in a domestic or commercial environment in a manner consistent with its specification and functionality, ii) the Product has been cared for reasonably and only subjected to reasonable wear and tear, iii) the defect has not been caused by willful or negligent abuse or neglect, or any accident or improper installation procedure, iv) the serial number of the Product has not been altered or removed.
- This warranty only applies to the original purchaser, and shall be the exclusive remedy to the original purchaser. PureLink shall not be liable for any damages whatsoever caused by Product or the failure of Product to perform, including incidental or consequential damages. PureLink shall not be liable for any claim made by a third party or made by the purchaser for a third party.
- Except as expressly set forth in this warranty, PureLink makes no other warranties, expressed or implied, including any implied warranties of merchantability and fitness for a particular purpose. PureLink expressly disclaims all warranties not satisfied in this limited warranty. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supersedes all previous warranties.
WARRANTY RETURNS/REPAIRS/EXCHANGES
- No merchandise may be returned without prior authorization from PureLink, and a Return Materials Authorization (RMA) number. Failure to comply with these conditions will result in rejection of the returned merchandise.
- Any warranty service on Products must be arranged through Dealer. Authorized returns must be shipped freight prepaid and fully insured to PureLink, Ramsey, NJ USA, with the RMA number clearly marked on the outside of all shipping boxes and containers. PureLink reserves the right at its sole discretion to refuse any shipments arriving freight collect or without an RMA number. Any authorized returned merchandise must be accompanied by a note describing the reason for return, along with contact information including name, phone number, return mailing and shipping addresses, e-mail address, and RMA number.
On any products returned and accepted with an RMA number, return freight charges following repair of items under warranty shall be paid by PureLink, shipping by the standard ground carrier of its choice.
ADVANCE WARRANTY REPLACEMENTS
- PureLink’s advance replacement service offers a Replacement Unit upon request – free of charge for eligible products purchased less than one (1) year of the warranty claim. Products purchased more than one (1) year prior to the warranty claim do not qualify for advance replacement services.
- Advance replacement requests must be validated by a member of PureLink’s Technical Support Team. Replacement units may be new or refurbished and is subject to availability. PureLink is responsible for shipping the Replacement Unit to your designated location by standard ground service. All other shipping methods will be responsibility of the Dealer.
- Original Unit Return – the Original Unit must be returned within thirty (30) calendar days of the return authorization date. Failure to return the Original Unit within this period will be subject to a minimum 15% re-stocking fee. Dealer is solely responsible for the shipping of the Original Unit to PureLink.
TO MAKE A WARRANTY CLAIM
To make a warranty claim, promptly notify PureLink within the warranty periods
described above by calling PureLink’s Technical Support Department at
1-201-488-3232. PureLink, in its sole
discretion, will determine what action, if any, is required under this
warranty.
Customer Service
Most problems can be corrected over the phone through close cooperation
between Customer and a PureLink technician. To better enable PureLink to
address a warranty claim, please have the Product’s serial and model numbers.
If PureLink, in its sole discretion, determines that an on-site visit or other
remedial action is necessary, PureLink may send a representative to Customer’s
site.
CUSTOMER SERVICE
Technical support inquiries can be submitted electronically at
www.purelinkav.com
For immediate assistance please contact PureLink’s Customer Care Team at +1
201-488-3232.