PureLink FiberX FX-I380 HDMI 8K AOC Cable Instruction Manual

PureLink FiberX FX-I380 HDMI 8K AOC Cable

INTRODUCTION

Thank you for purchasing the Fiber Optic HDMI 8K AOC Cable. This cable allows you to transmit HDMI signals to a distance of up to 100m without an external power supply. This cable is a hybrid cable containing both fiber optic and copper cores. Our HDMI Active Hybrid Cable is the most competitive long- distance HDMI interconnection solution on the market. It supports a maximum data rate of 12 Gbps per channel, is lightweight, flexible, and has an ultra- small fixed installation bending radius of 45mm. With our advanced optical engine embedded the HDMI Hybrid Cable provides full HDMI signal integrity.

INTENDED USE

This product is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all circumstances. For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the product for purposes other than those described above, the product may be damaged. In addition, improper use can cause hazards such as short-circuiting, fire, electric shock, etc. Read the instructions carefully and keep them. Make this product available to third parties only together with its operating instructions.

SAFETY INSTRUCTIONS

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in
this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/ guarantee. The device is not a toy. Keep it out of the reach of children and pets. The maximum pulling tensile load of the cable is 238 N (24 kg). Never pull the cable with a higher load. The minimum bending radius of the hybrid cable is approximately 45mm, bending the cable to a smaller radius will irreversibly destroy the cable. Pay attention to trip hazards; make sure that the cable is installed safely. Do not leave packaging material lying around carelessly. These may become dangerous playing material for children. Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, vapors, and solvents. Do not place the product under any mechanical stress. If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use.

Safe operation can no longer be guaranteed if the product:

• is visibly damaged
• is no longer working properly
• has been stored for an extended period in poor ambient conditions or
• has been subjected to any serious transport-related stresses.

Please handle the product carefully. Jolts, impacts, or a fall even from a low height can damage the product.
Also, observe the safety and operating instructions of any other devices which are connected to the product.
Consult an expert when in doubt about the operation, safety, or connection of the device.

DELIVERY CONTENT

1x HDMI 8K AOC Cable
1x User Manual DE/EN
1x Warning Insert

FEATURES

This HDMI 8K AOC Cable has many features that enable it to perform in a superior manner. Among those features you will find:

• Supports HDMI 8K specification with data rates up to 48Gbps
• Supports HDCP1.4, HDCP 2.2 and HDCP2.3
• Supports resolutions up to Ultra HD 8K (7680×4320) 60Hz, 4:4:4
• Supports computer resolutions including 1080P and 1080p, 4K2K and 8K4K (60Hz)
• Supports DCI, Static HDR, HDR10+, Dolby Vision, HLG, SL-HDR1, PQ, BT.2020, and BT.2100
• Supports lossless HDMI audio formats like 2ch PCM, Multi-channel LPCM, DTS-X, and Dolby Atmos
• Supports ARC, HEC, and CEC
• Supports EDID incl. self-detecting function
• Long-term bending radius (45mm)
• Plug and Play
• Low Power Consumption: 250mW (max) (Power Required)
• No loss of signal
• Delivering crystal clear digital images instantly

APPLICATION

This product is for example applicable to:

• Digital Signage
• LED Signboards
• Home Theater
• Blu-ray, 3D Video, Projector, Set-top box, DVR, Game Consoles and Computer
• TV Broadcast Station
• Conference Room
• Video Equipment
• Security Systems and more

SPECIFICATIONS

Mechanical properties and Environmental performance:

Item Units                                                              Specified values

*D = the diameter of the cable body, in this case, it is 4.5mm

Specifications

Item Description

communication

HDCP 1.4/2.2/2.3 pass through,Audio, CEC,

support HEC&ARC

Video Bandwidth| 48Gbps – 12Gbps per Channel + Clock
Supported

Resolution & Distance

| Max. resolutions: 8K (7680×4320) 60Hz 4:4:4 8/10bit

PC: WUXGA 1920×1200 up to 100 meters HDTV: 480p, 720p, 1080i and 1080p deep color, 4K (60P), 3D Full HD 1920×1080 up to

100 meters

O/E Converter| 4 channel 850 nm VCSEL array| 4 CH GaAs PD array
Connector Type| HDMI Typ A
Cable Type| Hybrid type with OM3 fiber and copper wire
Cable Outer Diameter| 4.5 mm
Jacket Outer Material| LSZH / CPR
Differential Input| 100 Ohm
Power Consumption| 250 mW (max.)
Power Supply| Non-external power required
Passive Power Supply| 4.75-5.5 V

Environmental Conditions

• Operating Temperature:
  – 10 – 50 °C 10 – 80 %RH

• Storage Temperature:
  – 20 – 60 °C

• Relative Humidity:
  “10 – 80 %RH

CROSS-SECTION

CROSS-SECTION
Construction:
Hybrid cable, fiber (high-speed data) & copper (low-speed signals)
Cable construction:
4 fiber cores and 7 cooper conductor hybrid cable, fiber (high-speed data) & copper (low-speed signals)
Cable construction:
4 fiber cores and 7 copper conductors

• Cable jacket:
  CPR

• Diameter:
  ~ 4.5mm

• Connector dimensions:
  ~ 50x20x11mm

• Connector material:
  Zinc Alloy

OPERATION AND CONNECTION DIAGRAM

Attention:
The FX-I380 series is designed for use with the +5V passive power, supplied through pin 18 on the HDMI connection from the source device. This +5V connection, as well as powering the internal fiber optic module, is also carried through to the other sink via a full standard copper connection. Please make sure, that the source device is capable of delivering more than 500mA. This cable can only be used in one direction. The connectors are marked with “SOURCE” and “DISPLAY”. Each connector must be plugged into the correct port to avoid signal loss. Before using this cable, please make sure that all devices which will be connected with the AOC HDMI Cable are shut down and without power. Then you can start to connect the “source-side” of the HDMI plug to the transmitter and connect the “display side” of the other HDMI plug to the receiver/display.
This works without additional power supply. We do not recommend using any intermediate cables or adapters between the connections, as the signal transmission performance may be attenuated. Switch on the power of the device of the HDMI source and the display.

If the system does not work properly, see troubleshooting guide in next section.

TROUBLESHOOTING

The Display shows:

• A black screen
• Screen is distorted
• Noise interference

1. Check that the connectors are in the correct ports of the source and sink devices – check the labels on the connector housing to be sure.
2. Ensure that the HDMI plugs are firmly inserted into the HDMI source and display.
3. Check if the HDMI source and display are powered on and properly booted.
4. Reset the system by unplugging and re-plugging the source or display HDMI port.
5. Reboot the system with the optical HDMI cable system reconnected.

MAINTENANCE

There are no components located inside the product you need to maintain. Never open/dismantle the product. Maintenance, modifications, and repairs are to be performed exclusively by an expert or at a qualified shop. If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.

CLEANING
Before cleaning the product it must be disconnected from all other connected products. Do not use abrasive or solvents or any aggressive cleaning agents, rubbing alcohol, or other chemical solutions as they can cause damage to the housing and malfunction. To clean the product, a dry, soft, and clean cloth are sufficient. Do not apply too much pressure to the housing as this may cause scratch marks. You can easily remove dust using a long-haired, soft, and clean brush.

WARRANTY AND LIABILITY

The producer grants 2 years warranty to a new device.
As the manufacturer has no influence on installation, warranty only applies to the product itself.
If any fault or damage is detected on your product, please contact your dealer and provide your sales slip or invoice as evidence of the purchase, if necessary. Your dealer will repair the fault either on-site or send the device to the manufacturer. You make the work of our technicians considerably easier, describing possible faults in detail – only then you can be assured that faults, occurring only rarely, will be found and repaired with certainty! The manufacturer is not liable for damages to persons or property caused by improper installation, operation, or maintenance, not described in this manual. Do not alter or modify the product or its accessories. Any use other than described in this user`s manual is not permitted and causes loss of warranty, loss of guarantee, and non-liability.

CE CONFORMITY
PureLink GmbH hereby declares that the FX-I380 Series complies with Directive 2014/30/EU. The full text of the EU Declaration of Conformity is available at the following Internet address:
www.purelink.de/ce/FX-I380-XXX_CE.pdf

DISPOSAL OF THE DEVICE
WEEE-Reg. No.: DE 93847290 According to the European WEEE directive, any electrical and electronic equipment must not be disposed of with consumers waste. As a consumer, you are committed by law to reposit electrical and electronic devices to public collecting points or to the dealer for free at the end of the device’s lifetime. Details are regulated in the respective national legislations. The garbage can symbol on the product, in the manual, or on the packaging refers to these terms. With the return of your used devices, you actively take part in protecting the environment.

DISCLAIMER

This product complies with the statutory national and European requirements. All company names and product names are trademarks of their respective owners. All rights reserved. We reserve our right for misprints and changes of the device, packing, or user`s manual. HDMI® is a registered trademark of HDMI Licensing L.L.C Dolby and the double-D symbol is registered trademarks of Dolby Laboratories.

PureLink GmbH
Von-Liebig-Straße 10
48432 Rheine
Deutschland
Tel.: +49 (0) 5971 800 299-0
Fax : +49 (0) 5971 800 299-99
info@purelink.de
www.purelink.de

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>