Allesgute IP44 LED Recessed Ceiling Downlight User Manual
- June 14, 2024
- Allesgute
Table of Contents
User Manual
IP44 LED Recessed Ceiling Downlight
| Package Included (For one set ) | Basic product information |
|---|
| Voltage| AC 220-240 V,50/60Hz
Material| Plastic
IP Rated| IP44
Beam Angle| 120°
Color Rendering Index| >80Ra
Dimmable| Not Dimmable
Guarantee| 2 Years
Cut-out size (0)| 60-68nnm(2-3/8″-2-5/8″)
Product size (0H)| 75mm(2-7/8″) 32mm(1-2/8″)
The Name and Content of Hazardous Substances
| Part Name | Harmful Substances |
|---|---|
| Pb | Hg |
| Light Fixture | 0 |
| Other Plastic Parts | X |
| Other Metal Parts | 0 |
| Other Printed Parts | O |
This form is in accordance with BS EN 60598-2-2:
: Indicates that the content of hazardous substances in related part is not
detected.
: Indicates that the content of hazardous substances in related part is below
the limit of requirement specified.
Common Troubleshooting
| Problem | Possible Cause | Suggested Remedy |
|---|---|---|
| Not work | Loose connection, damaged wiring. | Check wiring connections and |
tighten any loose connections. Inspect wiring
for any visible damage.
Flickers| Use a dimmer switch; The wire falls off/ loosens/breaks.| Check if
the wire is damaged or it is tightly connected.Use a normal light
switch because the lamp is not dimmable.
Overheating| Excessive wattage, extended usage time, improper installation
location, and circuit faults.| Reduce the number of light fixtures, control
the usage time, install the light fixtures in well-ventilated areas, and check
for circuit faults.
Emits buzzing or
humming sound| Loose light fixtures/ wiring,unbalanced equipment| Check and
tighten the light fixtures/ wiring, adjust the position of the equipment, or
replace the bracket.
Installation Steps
Preparation works:
- Installation shall be done by qualified technician only.
- Ensure power is off before all operation.
Hole cutting: Use a hole saw or dry saw to cut holes from 60 to 68 mm. Connect the cable: Connect the wires using the terminals to ensure a secure connection. Install the light: Attach the LED light to the ceiling by clamping the spring clip. Power on: Turn on the power to make sure it is working properly.
https://us20.list-manage.com/contact-
form?u=e4b35b5007c292d59067399ae&form_id=357759e64e49da8bd4d6a80ec43ac9eb
Contact us anytime
hiledservice@outlook.com
Contact us on Amazon directly
Scan the QR code on the right to contact us