TECNO POVA Neo 3 Full Smartphone User Manual

TECNO POVA Neo 3 Full Smartphone

Product Information

using fingerprint
NFC| Near Field Communication for contactless data transfer

Product Usage Instructions

SIM/SD Card Installation

1. Power off the mobile.
2. Refer to the user manual for SIM/SD card installation instructions.

Charging the Phone
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).

Important:
Use only TECNO charger and cables. Other chargers or cables may damage the device and invalidate your phone warranty.

FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Information to user:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Specific Absorption Rate (SAR) Information
This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement:
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device type LH6n (FCC ID: 2ADYY-LH6N) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.27W/kg and when properly worn on the body is 1.18W/kg.

Note: Android is a trademark of Google LLC.

Explosion diagram specification

FABRIC

9| PCBA COOPER| 10| R CAM CON FOAM
11| R CAM CON FB| 12| CAM AF
13| CAM FF| 14| F CAM FRAME
15| BAT RUBBER| 16| F CAM
17| F CAM COOPER| 18| R CAM RUBBER
19| R HOUSING ASM| 20| SCREW L3.5
21| SCREW L2.5| 22| R CAM FRAME
23| BATTERY ASM| 24| CAM DECO
25| RFLASH LENS| 26| CARD HOLDER
27| R CAM LENS 8M| 28| R CAM LENS 16M
29| SCREW L2.0| 30| WATERPROOF MYLAR
31| WATERPROOF FRAME| 32| COAXIAL CABLE
---|---|---|---
33| USB RUBBER| 34| TP BTB RUBBER
35| SIDEKEY FPC| 36| EARJACK RUBBER
37| FINGERPRINT ASM| 38| DOWN SPK
39| SUB LCM FPC| 40| MOTOR
41| SUB PCB| 42| SIDEKEY FPC MYLAR

Know your phone

1. Front camera
2. Volume + key
3. Volume – key
4. Power key & side fingerprint sensor
5. NFC

SIM/SD card installation

1. Power off mobile.
2. Refer to the following picture for SIM/SD card installation.

Charging the phone

• You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
• Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.

FCC Caution

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Information to user
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: LH6n(FCC ID:2ADYY-LH6N) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.27W/kg and when properly worn on the body is 1.18W/kg.

Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

HiOS runs on AndroidTM OS. Android is a trademark of Google LLC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>