WIPKVIEY T16 Mini RC Portable Drone User Guide

TY-T16 Unboxing and Setup Guide

Please strictly follow the instructions below, Otherwise, the drone may be damaged with a 99.99 % chance

T16 Mini RC Portable Drone

Shown as the picture, insert 3*AAA 1.5V batteries into the remote control, then cover the battery cover.

Shown as the picture, wiring the aircraft with power supply of battery (Red power supply wire align to the red power supply wire and connect, black power supply wire align to the black power supply wire and connect), and cover the battery warehouse cover.

Shown as the picture, place the aircraft on the ground at the correct direction.
Please connect the remote controller and aircraft and calibrating according to the steps on the below picture and text. Please attention, if not calibrating then the aircraft will generate the problems like incline flying, uncontrolled and flying loss and other problems. If the aircraft existing reverse place, incline, impact and other actions during flying, then you need close the remote controller and aircraft then restart, connect and calibrate again. Otherwise, the aircraft also will generate the problems like incline flying, uncontrolled and flying loss and other problems.

Shown as the picture, put the aircraft horizontally while matching the frequency.

Shown as the picture, press and hold the button for 3 seconds to start. (The indicator will shine quickly after turning on)

Shown as the picture, open the remote controller switch according to indicate direction. (Red lamp start flashing after heard one sound “beep” and start.)

Shown as the picture, push the left joystick up once.

Shown as the picture, push the left joystick down once. (At this point, the red light on the remote control and the aircraft will stay on, indicating that the remote control is connected to the aircraft.)

Shown as the picture, pull the left & right joystick diagonally down at 45° angle at the same time. (Now, the aircraft lamp change to be normally lighting after flashing, represent the aircraft calibration finished after send out one “beep” sound.)

Notice:

1. Once setup is completed, Push the left stick up once to activate the propellers, push it again to take off. please try to use the AIRCRAFT in a windless or light wind environment.
2. If the remote control light flashes during flight, please replace the remote control batteries promptly.
3.  If you hear continuous beeping sound from the remote controller during flight, please replace the aircraft battery promptly.
4. In view of safe transportation, the factory battery charge is low. Please fully charge it before using it!

Propeller Replacement Instructions:

Shown as the picture, please note the label (A or B) on the propeller when replacing it, and install it in the correct position as shown above.

Shown as the picture, make the correct impeller align to the joggle, then twist the screws and finish installation.

Charging Instruction:

Shown as the picture, firstly correctly connect the battery and charging wire, connect another end of charging wire to power supply of adaptor charging wire joggle then can charge.

Thank you for you trust and support us!

Documents / Resources

| WIPKVIEY T16 Mini RC Portable Drone [pdf] User Guide
A14LOZ0G0nL, T16, T16 Mini RC Portable Drone, Mini RC Portable Drone, RC Portable Drone, Portable Drone, Drone
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>