WIPKVIEY T27 QUADCOPTER Drone Camera Instructions

WIPKVIEY T27 QUADCOPTER Drone Camera

Product Information

Specifications

• Product Type: Quadcopter
• Frequency: 2.4GHz
• Channels: 6
• Age Range: Suitable for children over 14 years old

Part Identification

The product consists of the following parts:

• Aircraft
• Power switch
• The rear of aircraft
• The front of aircraft
• Remote control
• Camera (Optional)
• Blade A/B
• Protective cover
• Screwdriver
• Battery

Battery Installation and Charging

To install the battery, follow these steps:

1. Locate the battery compartment on the aircraft.
2. Open the compartment and insert the battery.
3. Close the compartment securely.

To charge the battery, use the provided USB charging cable. Connect one end of the cable to the aircraft and the other end to a power source. Ensure that the power source is compatible with the charging requirements of the battery. Allow the battery to charge fully before use.

Mobile Phone Fixture Installation

To install the mobile phone fixture, follow these steps:

1. Locate the mobile phone fixture on the remote control.
2. Open the fixture and place your mobile phone inside.
3. Adjust the fixture to secure your mobile phone.

Aircraft Calibration

To calibrate the aircraft, follow these steps:

1. Place the aircraft on a flat and stable surface.
2. Ensure that the power switch on the aircraft is in the “OFF” position.
3. Turn on the remote control.
4. Follow the instructions provided in the attached manual for the specific calibration process.

Aircraft Operation and Control

To operate and control the aircraft, use the remote control. The remote control features various buttons and joysticks for different functions:

• Fast and Slow Option: Control the flight speed of the aircraft.
• Photo/Video (Optional): Capture photos or record videos using the camera on the aircraft (if available).
• Headless Mode/One Key Return: Enter headless mode to simplify flight controls or press the One Key Return button for automatic return.
• Control the Throttle: Use the joystick to control the rise, fall, and rotation of the aircraft.
• One Key Take-off: Automatically initiate take-off at a height of approximately 1.5 meters.
• One Key Landing/Emergency Stop: Automatically land the aircraft or perform an emergency stop.
• Flip: Enter rolling mode to perform flips and stunts.
• Turn Right Fine-tuning: Assist in adjusting the aircraft to fly in left direction.
• Turn Left Fine-tuning: Assist in adjusting the aircraft to fly in the right direction.
• Control the Direction: Use the joystick to control the direction of the aircraft.
• Forward Fine-tuning: Assist in adjusting the aircraft to fly forward.
• Backward Fine-tuning: Assist in adjusting the aircraft to fly backward.

FAQ (Frequently Asked Questions)

Q: Can children under 14 years old use this product?
A: No, this product is suitable for children over 14 years old.

Q: How can I ensure the safety of myself and my children while using this aircraft?
A: Read the manual carefully before using the aircraft. Avoid picking up the aircraft while it is in motion to prevent injuries. Keep hands, hair, and loose clothes away from the rotary propeller. Children should be accompanied by adults while using the
aircraft.

Q: What should I do if the aircraft gets damaged accidentally?
A: In case of accidental damage, the manufacturer and its distributors, and retailers will not be liable for any legal liability.

Q: Is there a warranty for this product?
A: Please refer to the attached manual for warranty information or contact the manufacturer for further assistance.

SECURITY WARNING

• This product is a high-speed aircraft. improper use may cause damage to people or property in the vicinity, so the users must be away from people or property during use. In the case of accidental damage, the manufacturer and its distributors and retailers will not be liable for any legal liability.
• To ensure the safety of you and your children, please read this manual while playing with this aircraft.
• Do not pick up the aircraft in motion to avoid injuries.
• Keep hands, hair, and loose clothes away from the rotary propeller.
• To ensure the safety of children, adults please accompany children while playing this aircraft. (Without authorization, free change or modification of this product will damage your rights related to this product.)

Product packaging contents

Part identification

Aircraft

Remote control

1| Fast and

slow option

| Control the flight speed of the aircraft.
---|---|---

2

|

Photo/Video (Optional)

| Click once to shoot one picture by the camera on the aircraft. After that, the camera will quit automatically.Press the key for 2 seconds, the camera on the aircraft will shoot a video. Please it again from 2 seconds to quit. (the camera is an optional part).

3

| Headless

mode/ One

key return

| Click once during the flight of the aircraft to enter the headless mode.Press the button for 2 seconds and the aircraft will automatically return.

4

| Control the throttle| Stir the joystick forward or backward to control rise and fall, stir the joystick left or right to control left and right rotation.
5| One key take-off| After starting the aircraft, every time it is clicked, it automatically rises by about

1.5 m.

6

| One key landing/ Emergency stop| Click once during the flight of the aircraft and the aircraft will automatically land on the ground.Press the button for 2 seconds and the aircraft will stop in an emergency.

7

|

Flip

| Click once to enter the rolling mode,and the aircraft will automatically exit this mode after rolling.
---|---|---
8| Turn right fine-tuning| Assist in adjusting the aircraft to fly at left directions.

9

| Turn left fine-tuning| Assist in adjusting the aircraft to fly at right directions.

10

|

Control the direction

| Stir the joystick forward or backward to control the aircraft to move forward or backward, stir the joystick left or right to control the aircraft to fly at left or right directions.

11

| Forward fine-tuning| Assist in adjusting the aircraft to move forward .

12

| Backward fine-tuning| Assist in adjusting the aircraft to move backward .

13

| Power switch| Control power switch, turn right to plug in, turn left to disconnect power.

Battery installation and charging

1. Remove the battery cover.
2. Install 3 “AA” batteries, according to the correct polarity.
3. Close the battery cover

Battery installation of aircraft

1. Push the battery in the direction indicated to the clasp position.
2. Press lightly on the buckle position.
3. Push out the battery in the direction indicated

Lithium battery charging

Remove the battery from the aircraft, and then plug the USB charging cable into the USB interface or other USB of the computer. Then connect the plug of the USB charging cable to the socket. When the red light is on, it indicates that it is charging, The Indicator will be off to show fully charged.
Note : The USB charging line can be connected to most smartphone chargers or mobile power sources or USB interfaces in automobiles. The voltage in the USB interface is 5V±0.5v. (The current cannot be> 1A)

Mobile phone fixture installation

Install the blade / Protective cover

The blade of the aircraft is not the same for every piece. Each blade is marked with “A” or “B”. When installing the blade, please correctly install it according to the corresponding tag as shown below. When the blade is not properly installed, the aircraft will be unable to take off,or rollover or throw.

1. Install the blade as shown in the figure, pull out the nut first, and then lock it with a screw.
2. Install the protective cover as shown in the illustration. First, remove the protective cover and then install the protective cover.

Aircraft calibration

After matching the code between the aircraft and the remote control, put the aircraft on a horizontal plane,and push the “left joystick” and “right joystick” on the remote control until the navigation light flashes, as shown below. After the calibration is completed, the navigation light will return to normal. (When the aircraft is offset in any direction and fine-tuning cannot be adjusted, this calibration can be used for repair.)

Automatic setting height

This aircraft adopts a “barometer” module to achieve fixed height and hovering; use the left joystick (accelerator) to control rise/fall; loosen the left joystick (accelerator), the aircraft will hover at that height

Take-off

1. Put a fully charged battery into the aircraft and press and hold the aircraft power switch for about 2 seconds to start the aircraft. Then place the aircraft on level ground with the nose on the front. (At this time, the aircraft light will flash.)
2. Turn off switch of the remote control (the power indicator is on) push the left lever to the top and then to the end, Aircraft and remote control begin to match codes, after that, the power indicator of the remote control and the light of PRV will be always on.

Start /Close the aircraft (choose the “set height” function)

To Start the Drone:
Move the left lever (throttle lever) to the top， the aircraft blades will slowly rotate.

To close the Drone:

1. Dial the left joystick (throttle) to the bottom until the aircraft blades stop rotating.
2. After the aircraft lands on the ground, press the One-touch landing/Emergency Stop button( )for 2 seconds to turn off the aircraft. ( Emergency stop function cannot be used unless the aircraft needs to be urgently stopped when it is on the ground or in special circumstances.)

One key take-off (optional) / One key landing (optional)

• One key take-off
  After starting the aircraft, click the “one key take-off” ( ) button, the aircraft will rise to about 1.5m automatically. [No use of left joystick (accelerator)]

• One key landing
  Click the “one key landing” ( ) button, the aircraft will land on the ground slowly from any height. [No use of left joystick (accelerator)]

Aircraft operation and control

Caution : To avoid losing control, move the joystick slowly while operating the aircraft

Fine-tuning

If the aircraft deviates the direction (left/right turning, forward/backward, left/right side flight), push the fine-tuning key in the opposite direction.For example, as shown in the figure, push back when deviating forward

Sensitivity setting

This Aircraft can realize 3 modes: Medium speed Press the”Accelerate(H)”button to rise up the throttle, Press “Lower speed(L)to low down the speed(Default Low-speed mode when it just started):

1. After press the button of the remote control, The buzzer Sounds a ‘wow’ means low speed.
2. After press the button of the remote control, The buzzer Sounds 2 ‘wow’ means Medium speed.
3. After press the button of the remote control, The buzzer Sounds 3’wow’ means High-speed

Adjust the sensitivity of the Aircraft by this key,if the sensitivity is higher, the Aircraft responds more quickly, otherwise, it more slower.

Flip mode
This Aircraft can roll 360 degrees by the following operations. To better perform rolling function and ensure the Aircraft is 4 meters away from the ground, it is necessary to roll in the rising process. Thus, the height is more easily maintained after rolling.

Flip

Camera Use (Optional)

1. Connect to the power supply and then start the remote control with further coding.
2. Click the “camera/video” ( )button, the camera on the aircraft will take a picture. The camera mode will be automatically exited after shooting.
3. Press and hold the “Camera/Video” ( )button for 2 seconds, the camera on the aircraft will take a video, and then press and hold the “Camera/Video” ( )button for 2 seconds to exit the recording mode. (Camera is an optional accessory)
4. Exit the camera mode, turn off the power, and finally remove the SD card.

WARNING

1. Ensure operation according to the above steps.
2. When taking pictures, the time interval shall not be less than 2 seconds .
3. If an SD card cannot store data, please format it before use

Headless mode

• What is “headless mode”?
  Namely, during flying, no matter where the PRV is, and no matter what its direction is, as long as the operator presses the “headless mode/One key return” ( ) key, the PRV will automatically lock the flying direction.

• When will the operator use the “headless mode”?
  When the Aircraft is far from you and you cannot know its direction, you can press the “headless mode/One key return” ( ) key to control the return of the Aircraft.

• Use of “headless mode”

  • When matching code, the head of the Aircraft shall be in front (otherwise, the direction will be mixed when opening the “headless” mode).
  • To better use “headless” mode, before flying, it is necessary to establish a direction coordinate on the ground.
  • When you need to use compass mode, press the “headless mode/One key return”( ) key, and the Aircraft will automatically lock the flying direction.
  • When you do not need to use “flip/compass” mode, press “headless mode/ One key return”( ) key to exit

One key return mode

• When the Aircraft is far from you and you do not know its direction, you can click “headless mode/ one key return” ( ) mode and control its height by the left lever (the right lever is not used).
• When Aircraft is automatically returned to the visible range, push the lever in any direction or re-click the “headless mode/one key return” ( ) key to exit.

Fault removal

1. Remote control and Aircraft cannot match codes.
   Solutions: Check whether the throttle of the remote control is the lowest; when starting the code match, do not push other levers or click the fine- tuning key.

2. The propeller does not rotate or respond slowly.
   Solutions: (1) Lithium battery power is low. (2) You need to re-match codes .(3) push the throttle to the bottom to make the Aircraft land, and fly again after 3 seconds.

3. Aircraft shakes or vibrates during flying, noise is loud.
   Solutions: Check whether the motor, housing or blade is installed correctly or whether the cone is damaged.

4. The blade can rotate but Aircraft cannot fly.
   Solutions: Check whether A/B blades are installed correctly.

5. One or more motors cannot work.
   Solutions: (1) The motor is broken. Change it. (2) A transistor on the launch panel of the remote control is burned out. Replace it with a new remote control.

6. Four axles still drift during suspension after recalibration.
   Solutions: Put the Aircraft on a flat ground and put several layers of paper on its direction (the thickness of the paper depends on the degree of drift). Thus, you can calibrate the accelerometer and solve the drifting problem.

7. Can not roll
   Solutions: Low battery needs charging

List of accessories

MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>