YMOO RT5066R2 Wireless Audio Transmitter Receiver User Manual
- June 14, 2024
- YMOO
Table of Contents
RT5066R2 Wireless Audio Transmitter Receiver
User Manual
Technology Specification
General Specifications
Mode: | RT5066R2 |
---|---|
Transmission frequency : | 2.4G private protocol |
DSP: | 24bit/198Khz |
Main frequency: | 160MHz |
Flash: | 8Mb |
Power Management
Enter specifications: | 5V 1A adapter |
---|---|
Over voltage protection: | When the input voltage exceeds 15V, protection will |
automatically start
Antenna Configuration
Antenna
configuration:| Antenna configuration
Button and light
Power button:| Long press to turn on/off
Input/output Interface
DC 2.0:| Power input interface
RCA:| 3.5 stereo input/output interface
Key Indicators
Working Distance:| Accessible up to 100 meters, equivalent to 320 feet(NO
obstacle)
Accessible up to 30-50 meters, equivalent to 98-164 feet(Have obstacle)
Delay :| less than 20 ms(NO obstacle) 200ms (Have obstacle)
Sampling Rate:| 24bit/192kHz
Working current voltage:| 20mA/5V
Frequency range:| 20~20KHZ
Distortion:| <0.1%
Signal-to-noise
ratio:| 85DB
IN the BOX
Adapter*3: | IN:AC100~240V 50/60Hz OUT:DC 5V 1A |
---|---|
Power cable*3: | Comply with UL certification |
Audio cable*3: | RCA male to 3.5mm male |
Antenna*3: | 2DB gain |
Manual*1: | 1pcs |
RT5066R2 | Transmitter 1pcs |
Receiver 2pcs
Working Environment
Operating Temperature: | -20℃—60℃ |
---|---|
Storage temperature: | -30℃—75℃ |
Product Connection
Transmitter: | TV/PC/Smartphone/Projector/Tablet/MP3 player |
---|---|
Receiver: | Active Speaker/Active Subwoofer |
Working Instructions
Step for transmitter:| 1.power on RT5066 transmitter by charging cable.
2.Plug the RCA to 3.5mm jack cable . RCA to RT5066 Bluetooth transmitter and
3.5mm jack to TV/PC/Projector/MP3 Player
3.LED will be flashing
---|---
Step for Receiver:| 1.Power on two RT5066 receiver by charging cable.
2. Plug the RCA to 3.5mm jack cable . RCA to two RT5066 receiver and 3.5mm
jack to Active Speaker/Active Subwoofer.
3. LED will be flashing.When you complete both receiver and transmitter,the
LED will stay on without flash.That means they have paired successfully.You
can enjoy now.
Note on usage:| * Normally,when both transmitter and receivers charged,they
will pair automatically.LED of them will stays on blue
- If transmitter do not pair,please press the button of the transmitter until LED off.and then press until on,they will pair automatically.
- If receivers do not pair,please press the button of both transmitter and the falsifying receiver until LED off.and then press until on,they will pair
automatically。 - If it still do not work,please open the back of transmitter .
- Power on the transmitter use a toothpick or needles to reset the receiver ,press the receiver paring button to repair .
- If you have any questions about this, please refer to the video on the product page.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>