ZIOCOM PTX-BT4807B Bluetooth Receiver User Manual
- June 14, 2024
- ZIOCOM
Table of Contents
ZIOCOM PTX-BT4807B Bluetooth Receiver
Product Diagram
- Indicator Light
- Multifunction Button
- Audio Output
- Charging Port
Specifications
- Bluetooth Range up to 33 feet
- Battery Capacity 300mAh
- Working Time about 15 hours when fully charged
- Charge Voltage DC 5.0V
Power on/off
- Power on: Long press the multifunction button for about 2 seconds, the red indicator light stays on for 1 second then blue indicator light starts flashing.
- Power off: Long press the multifunction button for about 3 seconds, the red indicator light stays on for 1 second then goes off.
Bluetooth Pairing
- Before using the receiver for the first time, you must pair it with your smart device.
- Long press the multifunction button for about 5seconds, it will enter pairing mode when the red and blue indicator lights start flashing.
- Turn on the Bluetooth function of your smart device.
- Search for the Bluetooth devices and select “BT4807”.
- Enter the code “0000” if needed.
- If paring is successful, the blue indicator light will flash 2 times every 3 seconds.
- Connect the device to your headset / Home Speakers or Car Stereo System with 3.5mm audio cable.
- Now you can enjoy music through your headset,Home Speakers or Car Stereo System wirelessly.
Connect two Bluetooth devices at the same time
- Pair the Bluetooth receiver to the first smart device.
- After pair successfully, turn off the Bluetooth function of the first smart device.
- It will enter pairing mode again.
- Pair the Bluetooth receiver to the second smart device.
- After pairing successfully, turn on the Bluetooth function of the first smart device. Select the “BT4807″and click “connect”
- Two smart devices will both connect with the Bluetooth receiver at the same time.
Remark:
If you want to switch different smart device to listen music, please pause the
music of the first smart device, and then play the music on the second
smartdevice, it will switch to the music of the second smart device after a
few seconds.
Playing music
- Short press the multifunction button: Play/ Pause the music.
- Double press the multifunction button: Play the next song.
- Long press the multifunction button for about 1 second: Play the previous song.
NOTE:
Volume control functions must be controlled directly by your audio device.
FCC STATEMENT
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- This device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Note:This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>