reolink RLC-81MA 4K Dual Lens PoE Camera User Guide
- June 14, 2024
- reolink
Table of Contents
RLC-81MA
Quick Start Guide
What’s in the Box
Camera Introduction
Connection Diagram
Before using the camera, please connect your camera as instructed below to finish initial setup.
- Connect the camera to a Reolink NVR (not included) with an Ethernet cable.
- Connect the NVR to your router, and then power on the NVR.
NOTE: The camera should be powered with a 12V DC adapter or a PoE
powering device such as PoE injector, PoE switch or Reolink NVR (not included
in the package).
* You may also connect the camera to a
PoE switch or PoE injector.
Set up the Camera
Download and Launch the Reolink App or Client software, and follow the onscreen instructions to finish initial setup.
- On Smartphone
Scan to download the Reolink App.
https://reolink.com/wp-
json/reo-v2/app/download
Mount the Camera
Installation Tips
- Do not face the camera towards any light sources.
- Do not point the camera towards a glass window. Or, it may result in poor image quality because of the window glare by infrared LEDs, ambient lights or status lights.
- Do not place the camera in a shaded area and point it towards a well-lit area. Or, it may result in poor image quality. To ensure best image quality, the lighting condition for both the camera and the capture object shall be the same.
- To ensure better image quality, it’s recommended to clean the lens with a soft cloth from time to time.
- Make sure the power ports are not directly exposed to water or moisture and not blocked by dirt or other elements.
- With IP waterproof ratings, the camera can work properly under conditions like rain and snow. However, it doesn’t mean the camera can work underwater.
- Do not install the camera at places where rain and snow can hit the lens directly.
- The camera may work in extreme cold conditions as low as -25°C. Because when it is powered on, the camera will produce heat. You may power on the camera indoors for a few minutes before installing it outdoors.
Install the Camera
Drill holes in accordance with the mounting hole template.
NOTE: Use the drywall anchors included in the package if needed.
Install the mount base with the mounting screws included in the
package.
NOTE: Run the cable through the cable notch on the mount base.
To get the best field of view, loosen the adjustment knob on
security mount and turn the camera.
Stiffen the adjustment knob to lock the camera.
Troubleshooting
Camera is Not Powering On
If your camera is not powering on, please try the following solutions:
- Make sure your camera is powered properly. The PoE camera should be powered by a PoE switch/ injector, the Reolink NVR or a 12V power adapter.
- If the camera is connected to a PoE device as listed above, connect the camera to another PoE port and see if the camera will power on.
- Try again with another Ethernet cable.
Picture is not Clear
If the picture from the camera is not clear, please try the following
solutions:
- Check the camera lens for dirt, dust or spiderwebs, please clean the lens with a soft, clean cloth.
- Point the camera to a well-lit area, the lighting condition will affect the picture quality a lot.
- Upgrade the firmware of your camera to the latest version.
- Restore the camera to factory settings and check out again.
Spotlight is not On
If the spotlight on your camera is not on, please try the following solutions:
- Ensure the spotlight is enabled under Device Settings page via Reolink App/Client.
- Upgrade the firmware of your camera to the latest version.
- Restore the camera to factory settings and check out the spotlight light settings again.
Specifications
Hardware Features
Power: By PoE (802.3af)/DC 12V
Spotlight: 1pcs
Day/Night Mode: Auto Switchover
General
Operating Temperature: -10°C to 55°C (14°F to 131°F)
Operating Humidity: 10%-90%
Notification of Compliance
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:this device may not cause harmful interference,
and this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a esidential installation. This equipment generates uses and
can radiate radio frequency energy and,frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC RF Exposure Warning Statements
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment shall be installed and operated with
minimum distance 20cm between the radiator & body.
Simplified EU Declaration of Conformity
Reolink declares that the WiFi camera is incompliance with the essential
requirementsand other relevant provisions of Directive2014/53/EU, the PoE
camera and NVR is incompliance with Directive 2014/30/EU.
Correct Disposal of This Product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. Toprevent possible harm to the environment
or human health from uncontrolled waste disposal,recycle it responsibly to
promotethe sustainable reuse of material resources. To return your used
device,please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environment
safe recycling
Limited Warranty
This product comes with a 2-year limited warranty that is valid only if
purchased from Reolink Official Store or a Reolink authorized reseller.
NOTE: We hope that you enjoy the new purchase. But if you are not
satisfied withthe product and plan to return, we stronglysuggest that you
reset the camera to factory default settings and take out the inserted SD
card before returning.
Terms and Privacy
Use of the product is subject to your agreement to the Terms of Service and
Privacy Policy . Keep out of reach of children.
End User License Agreement
Reolink product, you agree to the terms of this End UserLicense Agreement
(“EULA”) between you and Reolink.
ISED Statements
This device contains licence-exempt transmitter(s)/re ceiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Radio Frequency Exposure Statement for IC
The device has been evaluated to meet general RF exposure requirements. The
device can be used in mobile exposure conditions. The min separation distance
is 20cm.
Technical Support
If you need any technical help, please visit our official support site and
contact our support team
REOLINK INNOVATION LIMITED
FLAT/RM 705 7/F FA YUEN COMMERCIAL BUILDING 75-77 FA YUEN STREET MONG KOK KL
HONG KONG
Product Ident GmbH
EU REP
Hoferstasse 9B, 71636 Ludwigsburg, Germany
Email: prodsg@libelleconsulting.com
UK REP
APEX CE SPECIALISTS LIMITED
Addr.: 89 Princess Street, Manchester, M14HT, UK
Email: info@apex-ce.com
January 2023
QSG1_A
58.03.005.0074
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>