LAMAX PartyGo1 Party Speaker User Guide

: June 13, 2024
: LAMAX

Table of Contents

Controls
LED signalling for pairing
Pairing
TWS
Switch music sources
Charging
Parameters
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LAMAX PartyGo1 Party Speaker

Controls

1| POWER| On/off (hold) Switch music sources – Bluetooth, microSD card and AUX (press
---|---|---
2| CHARGE STATUS| LED indication of battery charge status
3| PAIRING/ TWS| Pairing (press) TWS mode on/off (hold)
4| VOL –| Volume down (press) Previous track (hold
5| PLAY| Playback/pause (press) To activate the mobile assistant (2x press) To answer/end a call (press) To reject a call (on hold) Disconnect paired device (hold for 3s) Reset (hold for 8s)
6| 6 VOL +| Volume up (press) Next track (hold)
7| LED| Switching light mods (press)
8| BASS+| BASS+ mode on/off (press)
Others:
9| MicroSD card slot|
10| USB-A port|
11| Microphone input|
12| AUX port|
13| Power input|

LED signalling for pairing

Flashing blue – speaker is ready for pairing
Glows blue – speaker is paired
Flashes blue-white – speaker is ready for TWS pairing

Switch on / off :
To turn on the speaker, hold down the POWER button. The LED will light up and an audible signal will sound. Hold the same button to turn the speaker off.

Pairing

Turn on the speaker by holding down the POWER button. The LED will flash blue and the speaker is ready to pair.
Activate the Bluetooth connection on your phone or other device.
Select „LAMAX PartyGo1“ from the list of available devices. When pairing is successful, the speaker will beep and the LED will turn blue.

If there are problems with pairing, reset the speaker by holding the PLAY button for 8 seconds. Then proceed as described in section 1. in the Pairing chapter.

TWS

To pair two speakers with each other, turn on both speakers and make sure they are not paired with a multimedia device. Press the TWS button on one of the speakers you select as the main speaker, an audio signal will sound and the LED will turn white, while the LED on the other speaker will be off. If the pairing is successful, the LED will flash for 3 seconds. Then pair the main speaker with the multimedia device according to step 1 in the Pairing chapter. The main speaker will function as the left channel. Only through this main speaker can you control the functions for calls.
To unpair the speakers, press the TWS button on the main speaker.

Switch music sources

Press the POWER button to switch between Bluetooth, microSD card and AUX sources. By connecting a microSD card or the included 3.5mm audio cable, the speaker automatically switches to the appropriate mode. When playing via the audio input, you cannot control the songs directly on the speaker.

Charging

4 LEDs lit – battery is charged between 75% and 100%
3 LEDs lit – battery is charged between 50% and 75%
2 LEDs lit – battery is charged between 25% and 50%
1 LED blinking – battery is between 0% and 25% charged, need to recharge the battery soon

The speaker can be charged using the included USB cable from a suitable USB device – adapter, PC, power bank. Do not charge the speaker with higher input voltage and current than 5V/2A, the speaker may be damaged.