LAMAX NoiseComfort ANC Headphones User Guide
- June 3, 2024
- LAMAX
Table of Contents
LAMAX NoiseComfort ANC Headphones
Controls
INSTRUCTION
Turning On
Press for 2 seconds to turn on the headphones. This is accompanied by an
audible notification and the blue LED lights up.
Pairing
- The headphones automatically go into pairing mode the first time you turn them on. This is indicated by the LED alternately flashing red and blue.
- On your device, turn Bluetooth on and locate and select LAMAX NoiseComfort ANC in the list of available Bluetooth devices. After successfully pairing, there is an audible notification.
If you have trouble pairing, remove your headphones from the list of paired devices in your smartphone. Turn off the headphones and then hold the button for 5 seconds. The headphones turn on and automatically go into pairing mode. Pair the headphones again as in Step 2 above.
Active Noise Cancellation (ANC)
Press the ANC button to turn on. When ANC is on, the green LED next to the
charging connector is lit. To turn off ANC, press the button again:
The ANC function cannot be activated if an audio cable is connected.
ANC especially suppresses deeper frequencies. Human voices and higher
frequencies are minimally suppressed.
Turning Off
Press and hold the for 5 seconds to turn off the headphones.
Charging
To charge, connect the USB-C cable to the headphones and the other end to the
5V USB charger. The LED lights up red when charging and blue when fully
charged.
Parameters
| Wireless technology __ | Bluetooth 5.0 __ |
|---|---|
| Bluetooth range __ | up to 10 metres __ |
| Supported codecs __ | AAC, SBC __ |
| Battery capacity __ | 1050 mAh __ |
| Headphone charging time __ | 3 hours __ |
| Playback time __ | up to 50 hours __ |
| Playback time with ANC __ | up to 26 hours __ |
| Weight __ | 260 g __ |
Subject to printing errors.
The latest version of the user guide can be downloaded here:
https://www.lamax-electronics.com/downloads/lamax-noisecomfortanc/manual