Power LITE UDL10W LED Up Down Wall Lights Instruction Manual
- June 13, 2024
- POWER-LITE
Table of Contents
Power LITE UDL10W LED Up Down Wall Lights
Product Information
The LED Up/Down Wall Light (Models UDL10W and UDL27W) is a luminaire designed for wall installation. It provides both upward and downward lighting, creating a stylish and functional lighting solution for various indoor spaces. The luminaire features a non-replaceable light source, meaning that when the light source reaches its end of life, the entire luminaire needs to be replaced. The product requires professional installation by a licensed electrician.
Product Usage Instructions
- Before starting any installation, switch off the power supply.
- Ensure that you have all the necessary tools and accessories to complete the installation correctly.
- Read all the provided instructions thoroughly.
- Take out the lamp and accessories from the packaging.
- Take out the base from the lamp body.
- Fix the base on the wall securely and ensure that the wires go through the hole of the base.
- Set the wires respectively: L=BROWN, N=BLUE, and =YELLOW-GREEN.
- Get the lamp fixture back to the base and fix it securely.
- Switch on the power supply only after completing the entire installation and examining the circuit.
Note: It is important to follow basic safety precautions during installation and maintenance. Always ensure that the power is switched off and the fitting has cooled down before performing any maintenance, cleaning, changing the globe, or adjustment to the fitting. Do not install the luminaire near a heat source, and do not exceed the nominal supply voltage or amperage ratings. To avoid injury or damage to the fitting, make sure that power leads and screws are secure before connecting the power.
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following:
- Read all instructions.
- Licensed electrician for installation only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid injury or damage to the fitting, please ensure that power leads and screws are securebefore connecting the power.
Installation Procedure
WARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly.
Installation
-
Step 1
Take out the lamp and accessories. -
Step 2
Take out the base from the lamp body. -
Step 3
Fix the base on the wall and make the wires through the hole of the base. -
Step 4
Set the wires respectively. -
Step 5
Get the lamp fixture back to the base and fix it well. -
Step 6
Switch on after complete installation.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au