Q-TRAN SD-J-LARGE LED L-Shaped Brackets Installation Guide
- June 13, 2024
- Q-TRAN
Table of Contents
Q-TRAN SD-J-LARGE LED L-Shaped Brackets
DIMENSION
INSTALLATION INSTRUCTIONS
COMPONENTS & HARDWARE
HARDWARE
SS FLAT HEAD PHILLIPS #6×3/4”
WALL MOUNTING – WITH CLIPS
- 2 clips preinstalled for 4’ or less; 4 clips preinstalled for greater than 4’
- For VHB mounting of the fixture see pg4
-
Predrill holes in the mounting track with 16” on center spacing, being sure to avoid drilling through the mounting clips.
-
Mount the bracket onto the wall.
-
Mount the fixture onto the bracket, refer to fixture installation instructions for any additional steps.
WALL MOUNTING – WITH VHB
- For clip mounting see pg3
-
Predrill holes in the mounting track with 16” on center spacing
-
Mount the bracket onto the wall.
-
a. Using a 50/50 alcohol mix, thoroughly clean the backside of the Fixture and the bracket where Fixture will be installed. Allow 5 minutes to dry.
b. Peel back 0.5″ of the VHB tape’s protective film on one end and use firm pressure to adhere it to the desired surface, avoiding air bubbles. Continue peeling the film and adhering the tape in small sections until the entire length is installed
-
Remove the film and position the fixture onto the bracket.
Refer to the fixture installation instructions for any additional steps.
References
- Your Name as Your Email | Hover Realnames
- LED Lighting Systems, Linear LED Lights, LED transformers | Q-Tran
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>