Q-TRAN QZ-PH-0-10V LED Power Supply Installation Guide

Q-TRAN QZ-PH-0-10V LED Power Supply

Product Information

The QZ-PH/0-10V LED power supply is designed for use with LED light fixtures. It has a driver compartment and a wiring compartment for easy installation. The product comes in various wattages: 30W, 60W, 96W, 192W, and 288W. The QZ can be mounted vertically or horizontally and requires a stud for sufficient support. It has mounting tab slots and holes for secure installation. The power supply supports both phase dimming and 0-10V dimming.

Product Usage Instructions

1. Mounting the QZ-PH/0-10V LED power supply:
   • Place the power supply vertically or horizontally.
   • Use the supplied #6 flat head screws to secure the power supply.
   • Ensure the mounting tabs on the bottom of the enclosure are aligned with the mounting holes or slots.
   • If mounting horizontally, use the center holes or side slots of each mounting tab for sufficient support.
   • If mounting vertically, use the center holes or side slots of each mounting tab for sufficient support.
2. When installing multiple QZ power supplies:
   • Keep a separation of at least 3 inches between the enclosures to prevent the rise of ambient temperature.
3. Wiring diagram:
   • For phase dimming:
   • Use a two-conductor cable for wiring from the power supply to the light fixture.
   • Follow the provided wiring diagram for different wattages (30W, 60W, 96W, 192W, 288W) and the corresponding AC input, dim, and output connections.
   • Ensure the phase dimmer wire (pink or grey) is connected correctly.
   • For 0-10V dimming:
   • Use a two-conductor cable for wiring from the power supply to the light fixture.
   • Follow the provided wiring diagram for different wattages (30W, 60W, 96W, 192W, 288W) and the corresponding AC input, dim, and output connections.
   • Ensure the phase dimmer wire (pink or grey) is connected correctly.

INSTALLATION

LED POWER SUPPLY – QZ-PH/0-10V

TOP VIEW Required Hardware Mounting Foot:

Mounting

1. The QZ can be mounted either vertically or horizontally, utilizing the supplied screws and the mounting tabs on the bottom of the enclosure
   • CENTER HOLE
   • SIDE SLOTS
2. The QZ must be mounted into a stud for sufficient support, using either the center holes or the slots of each mounting tab
   • CENTER HOLE
   • SIDE SLOTS
3. When installing multiple QZ power supplies, separate the enclosures by 3” of space from edge to edge. This prevents the rise of ambient temperature between the power supplies.
   • Horizontal mount illustrated above
   • Vertical mount illustrated above

Wiring diagram

• Phase Dimming
• 0-10V Dimming

Wiring from power supply to light fixture must be two conductor cable

QZ 30W

• TOP VIEW
• WIRING COMPARTMENT VIEW

QZ 60W

• TOP VIEW
• WIRING COMPARTMENT VIEW

QZ 96W

• TOP VIEW
• WIRING COMPARTMENT VIEW

QZ 192W

• TOP VIEW
• WIRING COMPARTMENT VIEW

QZ 288W

• TOP VIEW
• WIRING COMPARTMENT VIEW

© 2023 Q-Tran Inc. All rights reserved 155 Hill St. Milford, CT 06460 203-367-8777 [email protected] www.q-tran.com

Specification is subject to change

Rev-08-09-23

References

• Your Name as Your Email | Hover Realnames
• LED Lighting Systems, Linear LED Lights, LED transformers | Q-Tran

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>