RUGGED RIDGE 13551.39 Dash Mounted Switch Pod and Multi Mount Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 13551.39 Dash Mounted Switch Pod and Multi Mount
Product Information
| Component | Quantity |
|---|---|
| Switch Pod and Multi Mount | 1 |
| Universal Ball Mount | 1 |
| Cap Piece | 1 |
| Wireless Charging Phone Mount | 1 |
| USB Charging Cord | 1 |
For warranty information, please visit www.Omix-Ada.com.
Product Usage Instructions
- Cut an opening for the switches, ensuring to score cut lines before cutting through plastic. Score inboard of the outer edge towards the center block to prevent the opening from being too large for the switch housing.
- Insert the switch into the opening cut in the previous step and trim the opening as needed.
- Remove the interior rubber liner by prying one of the corners to lift it.
- Remove the two Philips screws from inside the compartment. Place the Multi-Mount System into position, ensuring that the area is completely clean before installing. Reinstall the Philips screws removed in step 4 through the Multi-Mount System into the dash.
- Place the outer ring over the end of the ball mount.
- Press the phone mount into the ball mount.
- Pull the outer ring over the phone mount and thread it tightly to secure. Route the power cord from the charging base to the USB power port located on the dash.
Components
Switch Pod and Multi Mount……………..(1)- Universal Ball Mount………………………….(1)
- Cap Piece………………………………………..(1)
- Wireless Charging Phone Mount……….(1)
- USB Charging Cord……………………………(1)
Dash Mounted Switch Pod and Multi Mount, JL & JT
-
Cut opening for the switches. Score cut lines before cutting through plastic.
Note: Score inboard of outer edge towards center block. This will ensure opening is not cut too large for switch housing. -
Insert switch into opening cut in previous step. Trim opening as needed.
-
Remove interior rubber liner. You may need to pry one of the corners to lift.
- Remove the two Philips screws from inside of the compartment.
- Place Multi-Mount System into position. Ensure area is completely clean before installing. Reinstall Phillips screws removed from step 2 through multi-mount system into the dash.
- Place outer ring over end of ball mount.
- Press phone mount into ball mount.
- Pull outer ring over phone mount and thread tightly to secure.
Route power cord from charging base to the USB power port located on the dash.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>