CARVEN 2022 Toyota Tundra Cut and Clamp Installation Guide
- June 13, 2024
- CARVEN
Table of Contents
CARVEN 2022 Toyota Tundra Cut and Clamp
Overview
NOTE: Read before install. Carven Exhaust Inc,
recommends professional installation for all of our products. Install products
at your own risk.
Allow exhaust system temperatures to cool down, 2·3 hours after vehicle has
been running Is recommended. Refer to power tools and equipment manuals for
proper safety Instructions.
Safety wear Is recommended, serious Injuries and burns can occur If proper
safety precautions are not taken. If you have any questions please contact
info@carveoexhaut.com or
951-817-5101.
Carven Exhaust is not responsible for performance on Install nor warranty.
Customer to verify due diligence regarding install and warranty.
For more inS1all lnS1ruct1ons & tips please visit our YouTube channel carven
Exhaust.
Place top of clamp over non perforated section of tube, then slide clamp down to the slit section. Torque clamp bolt to 6SLBS.
Parts
- Bolts QTY: 2
- 3 band clamp QTY: 1
- 3 Flange basket QTY:1
- 3 Bolt on Exhaust Tip QTY:1
Assembly
Step 1:
- Be sure to leave OEM exhaust system bolted and tightened securely before cutting (all proper safety precautions should be taken)
Step 2:
- Using a Sawzall, cut 11/4″ in front of the muffler section towards the front of the truck
- Unbolt at flange NOTE: Place both OEM nuts In a safe location you will be utilizing the nuts to attach the Carven Exhaust Cut & Clamp
- Remove muffler from the three exhaust hangers that are holding It In place
Caution: Exhaust Muffler will be free from this point
Step 3:
- Attach Cut & Clamp to all three exhaust hangers
- Insert cut OEM tube Into the new kit and slide clamp Into place
Use Carven Exhaust flange gasket & bolts with the nuts to install on new system to rear flange section
Step 4:
- Slip over the 5″ Bolt on Exhaust tip
- Make any adjustments to tip/muffler section
- Fasten connections to spec