andis BTF2E Cordless Trimmer User Guide
- June 13, 2024
- Andis
Table of Contents
andis BTF2E Cordless Trimmer
Product Information
This product is the Andis trimmer, model BTF2E. It operates on a voltage range of 100-240V and a frequency of 50/60Hz.
Important Safeguards
- Read all instructions before using this Andis trimmer.
- Do not reach for an appliance that has fallen into water. Unplug immediately.
- Do not use while bathing or in a shower.
- Do not place or store the appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
- Always unplug this appliance from the electrical outlet immediately after using.
- Unplug this appliance before cleaning, removing or assembling parts.
- An appliance should never be left unattended when plugged in.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Product Usage Instructions
-
Attach the desired trimming comb by sliding the front of the comb over the teeth of the blade and snapping it down over the back of the blade. Refer to Diagram G for visual instructions.
-
After attaching the trimming comb, turn on the trimmer and start trimming the hair with the natural grain. For a closer trim, choose one of the closer cutting comb attachments provided (refer to Diagram D)
. -
When trimming is complete, slide the on/off switch to the off position and remove the trimming comb (if being used).
-
Lightly brush out the blades with the blade cleaning brush provided. For best results, apply a drop of Andis clipper oil to the blade when necessary.
-
Do not use the trimmer to cut dirty or abrasive material. Avoid using it while bathing or in the shower to prevent damage to the batteries and product.
-
To trim the neckline, comb the hair into its natural position and choose an attachment comb for the desired length of cut. Trim with the natural grain of the hair. Use a comb to hold the hair in position if needed.
Note: In case of failure to charge, first ensure that voltage is present at the wall outlet by confirming with a working appliance. Check that the adapter cord is firmly plugged into the trimmer and twist the adapter connector slightly for a good electrical connection. If charging still fails, return the trimmer to Andis or an Andis Authorized Service Station for examination, repair, or replacement.
Congratulations! You just went First Class when you bought this Andis trimmer. Careful workmanship and quality design have been the hallmarks of Andis products since 1922.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be
followed, including the following: Read all instructions before using this
Andis trimmer.
DANGER: To reduce the risk of electric shock:
- Do not reach for an appliance that has fallen into water. Unplug immediately.
- Do not use while bathing or in a shower.
- Do not place or store the appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
- Always unplug this appliance from the electrical outlet immediately after using.
- Unplug this appliance before cleaning, removing or assembling parts.
WARNING: To reduce the risk of burns, fi re, electric shock, or injury to persons:
- An appliance should never be left unattended when plugged in.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Andis.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to an Andis Authorized Service Station for examination or repair.
- Keep the cord away from heated surfaces.
- Never drop or insert any object into any opening. Insert only recharging transformer plug into trimmer receptacle.
- Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use this appliance with a damaged or broken blade or comb, as injury to the skin may occur.
- Always attach plug to appliance fi rst, then to outlet. To disconnect turn control to “Off” then remove plug from outlet.
- WARNING: During use, do not place or leave appliance where it may be 1) damaged by an animal or 2) exposed to the weather.
SAVE THESE INSTRUCTIONS
UNIVERSAL AC/DC POWER ADAPTER
The unit/charging stand is equipped with a universal AC/DC power adapter. Three interchangeable input plugs are included for use in most countries around the world (Diagram A).
- Removing input plug:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on plug until it releases from power adapter.- Replacing input plug:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on input plug (Diagram B).
2. Gently push input plug into power adapter until it snaps into place.OPERATING INSTRUCTIONS
Please read the following instructions before using your new Andis trimmer.
Give it the care that a fi ne precision built instrument deserves and it will
give you years of service.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- The battery is not intended to be replaced by the user.
- The battery must be removed from the appliance before it is scrapped.
- The appliance must be disconnected from the supply mains when removing the battery.
- The battery is to be disposed of safely.
CHARGING UNIT – READ THE FOLLOWING BEFORE CHARGING TRIMMER
Remove the Andis cordless rechargeable trimmer and AC adapter from the carton.
Plug the adapter into a 230V AC outlet, or according to your local power
standards. Note that the trimmer ON/OFF switch must be in the OFF position for
the battery to charge. Plug the adapter cord directly into the trimmer
(Diagram C). The green light on the trimmer will turn on. The trimmer has not
been charged at the factory. Please charge the trimmer for 12 hours
(overnight) before the fi rst use for maximum performance. You can keep the
trimmer plugged into the adapter when not in use. The adapter will maintain
the battery at full charge and the green light will stay on. The unit has a
Nickel Metal Hydride battery that cannot be damaged by overcharging. However,
we recommend that the adapter be unplugged if the trimmer won’t be used for
seven or more days.
PLEASE NOTE: Nickel Metal Hydride batteries have less “Memory Effect”
than Nickel Cadmium batteries. Memory Effect is caused by repeated short uses
of the trimmer, followed by charging.
The battery never fully discharges and, therefore, “forgets” how much energy
it can store.
In order to maximize the performance of your Nickel Metal Hydride battery,
please follow these steps:
- Oil blade. Turn trimmer on and allow it run until the blade slows signifi cantly. It is not necessary to let the blade stop completely.
- Turn trimmer off. Charge overnight.
- Conduct the above exercise every sixty days.
ATTENTION: The product you have purchased contains a rechargeable battery. The battery is recyclable. Please dispose of this battery in a responsible manner. Check with your local solid waste offi cials for the details in your area for recycling options or proper disposal.
FAILURE TO CHARGE
- Make sure voltage is present at the wall outlet (confi rm with an appliance you know is working).
- Check to make sure adapter cord is plugged fi rmly into trimmer. Twist the adapter connector slightly to insure good electrical connection. If failure to charge still exists, return trimmer to Andis or an Andis Authorized Service Station for examination and repair or replacement.
USING TRIMMING COMBS
Your cord/cordless rechargeable trimmer comes complete with six trimming
guides. They are 1/2″, 3/8″, 1/4″, 7 day, 5 day and a 3 day for even closer
trimming (Diagram D).
ATTACHING THE TRIMMING COMBS
Slide front of comb over the teeth of the blade. Snap comb down over back of
blade (Figure G).
BLADES
When trimming is complete, slide on/off switch to off position and remove the
trimming comb
(if being used). Lightly brush out blades with the blade cleaning brush
provided. For best results
put a drop of Andis clipper oil on the blade when necessary. Motor bearings
are permanently
lubricated–do not attempt to oil. Blades should be handled carefully and never
bumped or used
to cut dirty or abrasive material. Do not use while bathing or in the shower,
as damage to
batteries and product may occur.
TRIMMING NECKLINE (Diagram H)
Your cordless rechargeable trimmer makes trimming the neckline easier. The
results are professional, too. Simply comb hair into natural position and
choose an attachment comb for the length of cut desired. Trim with the natural
grain of the hair. You may wish to use a comb to hold the hair in position
until you feel comfortable using your trimmer. For a closer trim, you may wish
to select one of the closer cutting comb attachments (Diagram D).
TRIMMING BEARD (Diagrams I, J & K)
Always begin with a slightly damp beard for more control when shaping. Comb
your beard in the direction the hair grows, to give you an indication of what
areas you need to trim. To trim the outer edge of your beard and add defi
nition, hold the trimmer horizontally with on/off switch facing out. Following
the line of your jawbone, cut away longer hairs along the outer edge of your
beard. To trim your beard line, hold the trimmer vertically (on/off switch
facing you). Start at the trimmed edge of your beard and, with a downward
motion, trim the area right under your beard line. For added defi nition of
your beard line, use the horizontal position to trim any stray hair.
TRIMMING MUSTACHE (Diagram L)
Always begin with a slightly damp mustache. When trimming your mustache the fi
rst few times you may wish to use a comb to hold in place while you trim. As
the hair is held in place, trim the hair ends (on/off switch facing out using
an upward motion). Once you feel comfortable using your cordless rechargeable
trimmer, you may wish to use it without the comb. Simply place a fi nger on
upper lip to lift hair away from skin and trim mustache using an upward
motion. When you’ve achieved the desired length, use a downward motion to
blend the hairs of your mustache. Be sure to trim slowly and gently. Too much
pressure too quickly may trim off too much.
USER MAINTENANCE
The internal mechanism of your trimmer has been permanently lubricated at the factory. Other than the recommended maintenance described in this manual, no other maintenance should be performed, except by Andis Company or an Andis Authorized Service Station.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
(Trimmer shown in diagrams may vary from the one that you have) The blades should be oiled before, during, and after each use. If your trimmer blades leave streaks or slow down, it’s a sure sign that the blades need oil. The trimmer should be held in a position shown in Diagram E to prevent oil from getting into the motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter blades (Diagram F). Wipe excess oil off the blades with a soft dry cloth. Spray lubricants contain insuffi cient oil for good lubrication, but are an excellent trimmer coolant. Always replace broken or nicked blades to prevent injury. You can clean the excess hair from your blades by using a small brush or old toothbrush. To clean the blades we suggest immersing the blades only into a shallow pan of Andis Clipper Oil, while the trimmer is running. Any excess hair and dirt that has accumulated between the blades should come out. After cleaning, turn your trimmer off, dry the blades with a dry cloth and start clipping or trimming again.
FACTORY REPAIR SERVICE
When the blades of your Andis trimmer become dull after repeated use, it is
advised to purchase a new set of blades available through your Andis supplier
or through an Andis Authorized Service Station.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
To fi nd an Authorized Repair Station go to www.andis.com
ABOUT COMPANY
- 1800 Renaissance Blvd., Sturtevant, WI 53177 U.S.A.
- 1-262-884-2600
- www.andis.com
- info@andisco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>