Andis HS-2 Ceramic Ionic Styling Hair Dryer User Manual
- June 13, 2024
- Andis
Table of Contents
Andis HS-2 Ceramic Ionic Styling Hair Dryer
IMPORTANT SAFEGUARDS
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following: Read all instructions before using. Keep away from water.
DANGER: As with most electrical appliances, electrical parts are electrically live even when the switch is off. To reduce the risk of death by electric shock:
- Always “unplugit” immediately after using it.
- Do not use it while bathing.
- Do not place or store appliances where they can fall or be pulled into a tub or sink.
- Do not place in or drop into water or other liquid.
- If an appliance falls into water, “unplug it” immediately. Do not reach into the water.
WARNING: To reduce the risk of burns, electrocution, fire, or injury to persons:
- An appliance should never be left unattended when plugged in.
- Close supervision is necessary when this appliance is used by, on, or near children or individuals with certain disabilities.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Andis.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been damaged, or dropped into water. Return the appliance to an Andis-authorized service station for replacement if under warranty.
- Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
- Never block the air openings of the appliance or place it on a soft surface such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, etc.
- Never use it while sleeping.
- Never drop or insert any object into any openings.
- Do not use outdoors, or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use an extension cord with this appliance.
- Do not direct hot air toward eyes or other heat-sensitive areas.
- Attachments may be hot during use. Allow them to cool before handling.
- Do not place the appliance on any surface while it is operating.
- While using the appliance–keep your hair away from the air inlets.
- Do not operate with a voltage converter.
- Be sure the voltage selector switch is in the correct voltage position before operating. Before plugging in, read the information about voltage selection contained in the Operating Instructions section of this manual.
- This appliance was set at the factory to operate at 125 volts. Refer to the Operating Instructions section of this manual for conversion to 250-volt operation.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, the plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still doesn’t fit, contact a qualified electrician. Do not attempt to defeat this safety feature. If this unit shuts itself off, first press the reset button on the ALCI plug. If it still does not run, the thermal protectors that are built into this dryer may have operated. If the unit still does not run after being allowed to cool, return the unit for servicing.
ALCI SHOCK PROTECTION
This Andis hair dryer has been manufactured with an appliance leakage circuit interrupter (ALCI) (Figure A) This mechanism will shut the dryer off (making it inoperable) under abnormal conditions, such as falling or being immersed in water. The ALCI shock protection is equipped with a test and a reset button.
TEST BEFORE EACH USE
- Plug the ALCI Shock Protection Plug into a 110-120 volt electrical outlet (ordinary household current). Do not attempt to use any other electrical outlet.
- Before attempting to switch the dryer on, perform the following test: Press the test button, and the reset button should pop up. This confirms that the safety plug is working properly.
- Now press the reset button and your dryer will be operable and the power switch of your dryer may be turned on for normal use.
- If the dryer does not operate properly, it should be either returned to an Andis-authorized service station for examination or discarded.
VOLTAGE SELECTION
Be sure the dryer is OFF before attempting to change the voltage selection. To set the required voltage, slide the voltage selector switch (on the side of the dryer) to the appropriate voltage marking (Figure B). For use in the U.S.A., the voltage selector switch should be placed in the 125-volt position. For use in several countries overseas, the voltage selector switch may need to be placed in the 250-volt position. Confirm the voltage available at each overseas location before using the dryer.
When operating at 250 volts, the unit will only work with the switch in position LOW. This setting will provide high heat and high blower speed. Do not try to operate with the switch in position HIGH when operating at 250 volts. For connection to a 250-volt supply, use an attachment plug adapter of the proper configuration for the power supply receptacle.
AIR/HEAT SETTINGS
At the 125-volt position, there are 3 air/heat settings: LOW, MEDIUM, and HIGH (Figure C). Note the MEDIUM and HIGH settings have the same airflow speed, however, the HIGH uses a higher temperature setting for faster drying. At the 250-volt position, only the LOW setting is available.
COOL SHOT
This dryer is equipped with a cool shot button (Figure C). To deliver a cool shot of air, press the button on the front side of the handle. The cool shot is ideal for locking in curl for a longer longer-lasting style. Just concentrate cool air on the desired curl until set.
USING ATTACHMENTS
This dryer comes with an attachment brush, a wide-tooth, and a fine-tooth attachment comb. To use an attachment, simply slide on and slide off of the dryer (Figure D).
CERAMIC TECHNOLOGY
This dryer uses ceramic technology to provide healthier hair compared to standard dryers. Ceramic technology also helps keep the heat even and consistent, to reduce drying times and minimize stress and damage to the hair.
USER MAINTENANCE
This appliance does not require special maintenance, cleaning, or lubrication. Service only through Andis authorized service stations. To contact Andis directly, please call our Customer Support Team at 1-800-558-9441 or email us at support@andisco.com. Untwist the cord before use. After use, re-wrap the cord and store the unit in a safe place. Do not wrap the cord tightly around the dryer. Do not hang the dryer by the power cord.
CLEANING
Unplug the dryer before cleaning. Clean the external surfaces of the dryer with a sponge or soft rag moistened with a mild soap and water solution. Do not use harsh cleaners, detergents, or solvents. Dry the dryer thoroughly before use. You can also clean the screen with a vacuum cleaner.
MANUFACTURER’S 60 MONTH LIMITED WARRANTY
This Andis product is warranted against defective material or workmanship for 60 months from the date of purchase. All express and implied warranties arising out of and applicable to the product by virtue of State law shall also be limited to 60 months from the date of purchase. Any Andis product determined by Andis to be defective in material or workmanship during the warranty period will be repaired or replaced, at Andis’ sole discretion, without cost to the consumer for parts and labor. To qualify for this limited warranty, the defective product must be returned via parcel post insured or U.P.S., with proof of purchase to Andis, 1800 Renaissance Blvd., Sturtevant, WI 53177 USA.
Please include a letter describing the nature of the problem. Due to foreign matter sometimes found in hair and for other reasons, clipper blades or the resharpening of blades are not subject to this limited warranty. Andis will not be responsible for the replacement, cost of repairs, or alterations made to its products by any other person, agency, or company. Except as stated above, Andis does not provide and expressly disclaims any implied warranty of merchantability or fitness for a particular purpose or any other warranty of any kind whatsoever. Under no circumstances will Andis be responsible for incidental or consequential damages of any type, or for any liability arising out of the use of unauthorized attachments. Some states may not allow the exclusion or limitation of incidental or consequential damages, so this limitation or exclusion may not apply to you.
Date Purchased____ Model__
To find an Andis Authorized Service Station near you log on to andis.com or contact our customer service department: at 1-800-558-9441
WARNING: NO WARRANTY IF PURCHASED FROM UNAUTHORIZED SELLERS OF ANDIS PRODUCTS
To ensure you are receiving an authentic, safe, quality product, you must purchase Andis products only through authorized sellers. Log on to andis.com or contact our customer service department at 1-800-558-9441 (U.S.) to review a list of our authorized sellers. These sellers are approved or certified by our company. If you do not purchase through one of these companies, we cannot assure the authenticity or condition of any Andis products, nor can we offer our warranty and related services for any products purchased from an unauthorized seller. Any such warranty is void and any warranty claim made for a product purchased from an unauthorized seller will be denied. Any sale or use by these unauthorized sellers of our products, and the marketing images, logos, trademarks, and copyrighted material on our products, is also unauthorized.
FAQs
What is the Andis HS-2 Ceramic Ionic Styling Hair Dryer?
The Andis HS-2 Ceramic Ionic Styling Hair Dryer is a professional-grade hair dryer designed for efficient drying and styling of hair. It features ceramic and ionic technology for smoother, shinier results.
What are the key features of the Andis HS-2 Hair Dryer?
The Andis HS-2 Hair Dryer boasts features such as ceramic and ionic technology, multiple heat and speed settings, a cool shot button, and a lightweight ergonomic design for comfortable use.
How does ceramic technology benefit hair drying?
Ceramic technology helps distribute heat evenly, preventing hotspots that can damage hair. It also emits far-infrared heat that gently dries hair from the inside out, reducing frizz and enhancing shine.
What is the significance of ionic technology in this hair dryer?
Ionic technology generates negative ions that break down water molecules on the hair's surface. This results in faster drying, reduced static, and smoother, healthier-looking hair.
Can I adjust the heat and speed settings on the Andis HS-2?
Yes, the hair dryer offers multiple heat and speed settings, allowing you to customize your drying and styling experience according to your hair type and preferences.
What is the purpose of the cool shot button?
The cool shot button provides a blast of cool air, which is useful for setting your hairstyle and adding shine. It's an excellent finishing touch to your styling routine.
Is the Andis HS-2 suitable for all hair types?
Yes, the Andis HS-2 is designed for use on all hair types. Its adjustable settings make it versatile enough to cater to different hair textures and styling needs.
Is the Andis HS-2 suitable for professional use?
Yes, the Andis HS-2 is often used by professionals in salons due to its high- quality performance and features. However, it's also suitable for home use.
What precautions should I take when using this hair dryer?
To ensure safe usage, avoid using the hair dryer near water, keep the cord away from heated surfaces, and unplug it when not in use. Additionally, do not block the air intake and keep it clean.
How do I clean the air intake of the Andis HS-2?
Cleaning the air intake is important for maintaining optimal performance. To clean it, first, make sure the hair dryer is unplugged. Use a brush or a cloth to remove any dust or debris from the air intake.
Is there a warranty for the Andis HS-2 Hair Dryer?
The warranty coverage for the Andis HS-2 may vary depending on the retailer and region of purchase. Check the warranty information provided with your product for specific details.
Can I use the Andis HS-2 Hair Dryer with a voltage converter when traveling internationally?
Yes, if you plan to use the hair dryer in a region with a different voltage standard, you can use a suitable voltage converter or adapter to ensure compatibility.
Is the Andis HS-2 Hair Dryer lightweight and comfortable to use?
Yes, the Andis HS-2 is designed with user comfort in mind. It is lightweight and features an ergonomic design, making it comfortable to hold and use for extended periods.
Video- Product Introduction
Download this PDF Link: Andis HS-2 Ceramic Ionic Styling Hair Dryer User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>