APS WB-FN175MD 6 Inch Tubular Drop Down Style Nerf Bars Running Boards Installation Guide
- June 1, 2024
- APS
Table of Contents
APS WB-FN175MD 6 Inch Tubular Drop Down Style Nerf Bars Running Boards
PARTS LIST
| 1 | Driver/left Running Board | 24 | 10mm x 27mm x 3mm Washers |
|---|---|---|---|
| 1 | Passenger/right Running Board | 12 | 10-1.5mm Nylon Lock Nuts |
| 6 | Mounting Brackets (left or right) | 18 | 8mm x 24mm x 2mm Washers |
| 18 | 8mm Plastic Retainers | 18 | 8-1.25mm Nylon Lock Nuts |
| 12 | 10-1.5mm x 35mm Hex Bolts |
PROCEDURE
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
-
Start the installation under the driver/left side of the vehicle. Locate the front factory running board mounting location along the inner side of the body, (Figure 1). IMPORTANT: Clean mounting studs with wire brush to remove paint and debris.
-
Slide (1) Plastic Washer over each of the (3) factory mounting studs in the body panel, (Figures 2 & 3).
IMPORTANT: The Plastic Washers are designed to prevent corrosion between the aluminum body panel and the steel mounting brackets. Do not install the Brackets without the Plastic Washers. -
Select (1) Mounting Bracket. NOTE: All (6) Brackets are universal and will fit left or right side. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figures 4 & 5). Leave brackets loose at this time.
-
Repeat Steps 1—3 to install the center and rear driver side Brackets, (Figure 6).
-
Carefully unwrap and select the driver/left Running Board. IMPORTANT: The front and center mounting tabs on the Running board are slightly closer to the front end of the Running Board.
-
With assistance, line up the Running Board with the back of the Brackets. Attach the tabs on the Running Board to the rear facing side of the Brackets with (6) 10mm x 35mm Hex Bolts, (12) 10mm Flat Washers and (6) 10mm Nylon Lock Nuts, (Figures 7—9). Do not tighten hardware at this time.
-
Level and adjust the Running Board as necessary and fully tighten all hardware.
-
Repeat Steps 1—7 for the passenger/right side Running Board installation.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Running Board.
INSTALLATION INSTRUCTIONS
Driver/left Side Installation Pictured
Documents / Resources
| APS
WB-FN175MD 6 Inch Tubular Drop Down Style Nerf Bars Running
Boards
[pdf] Installation Guide
WB-FN175MD, WB-FN175BD, HW-WB-FN175, WB-FN175MD 6 Inch Tubular Drop Down Style
Nerf Bars Running Boards, 6 Inch Tubular Drop Down Style Nerf Bars Running
Boards, Tubular Drop Down Style Nerf Bars Running Boards, Drop Down Style Nerf
Bars Running Boards, Style Nerf Bars Running Boards, Nerf Bars Running Boards,
Bars Running Boards, Running Boards, Boards
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>