GOAL ZERO 3600 W Passthrough Cable Installation Guide

3600 W PASSTHROUGH CABLE
Install Guide

DISCLAIMER

Please read all warnings, instructions and cautions carefully before use to avoid personal injury, property damage or damage to your Goal Zero product. Goal Zero reserves the right to update this document without prior notice.
Please visit www.goalzero.com to find the latest product information and the most recent version of the User Guide.

Note: This product should be installed by a licensed electrician following NEC guidelines.
This installation guide provides brief instructions that are intended only for professionals.

UL 94 V-0 rated

ITEMS PROVIDED BY GOAL ZERO

• Haven 10 Manual Transfer Switch, SKU: 70050

  •   * Yeti Extension Cable

• 3600 W Passthrough Cable (8 ft Flying Leads to Power + Male Cable, SKU: 98760)

ITEMS PROVIDED BY INSTALLER

Note: The Haven 10 allows for the inlet to be relocated from the Haven 10 unit to a remote location. This requires the installer to provide a generator power inlet, which is available from Reliance directly.

• 40 A double pole 120 V Breaker

• Gang Box

• Wall Outlet (Goal Zero recommends
  NEMA L14-30R)

• Wiring needed to connect the breaker to the in-wall outlet

  •   * Use 8 AWG wire to comply with NEC rules

• A plug to terminate the 3600 W Passthrough Cable (Goal Zero recommends NEMA L14-30P)

INSTALLING THE 3600 W PASSTHROUGH
This cable replaces the power cord that is included with the Yeti PRO. Please keep the power cord in case you need it in the future. The 3600 W Passthrough Cable provides the following benefits:

• It allows for automatic power switching up to 3600 W in less than 10 milliseconds when the Yeti PRO 4000 is plugged in and the circuits are connected through the Haven 10 Manual Transfer Switch

• It allows you to charge the Yeti PRO 4000 while simultaneously passing through power to your circuits.

  •   * Passthrough capability up to 3600 W when the Yeti PRO is completely charged.  

    (120 V only)

  • If charging at 1800 W, it can continue to pass through another 1800 W. The Yeti will prioritize pass-through over chraging

  •  3600 W passthrough cable provides power to both L1 and L2 of the Haven 10.
    There is no option to supply 240 V loads from this cable. The Haven 10 should be configured with 120 V loads only.

INSTALLATION

NOTE: Follow National Electrical Code (NEC) standards throughout each step of the installation

1. Install the double pole 40 A 120 V breaker at the breaker panel
2. Install the gang box and wall outlet
3. Connect the breaker to the in-wall outlet using suitable 8 AWG wire
4. Install a plug for the in-wall outlet
5. Plug the Power+ end of the 3600 W Passthrough Cable into the Power + port on the Yeti PRO 4000
6. Terminate the bare ends of the 3600 W Cable with the plug that corresponds with your wall outlet.
   a. For this configuration we will only be using one leg of the 240 V supply. It does not matter which leg you use.
   b. Green is Ground
   c. White is Neutral
   d. Black is L1 or L2

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>