Bird-X Scare Eye Repeller Instruction Manual
- June 7, 2024
- Bird-X
Table of Contents
Instructions for Installation of Bird-X Scare Eye Repeller
The Scare Eye will scare away flocks of nuisance birds that are repelled by
its bright color and unusual design. The eyes exaggerate the glaring eyes and
gaping mouth of a predator bird. Its waving streamers and bobbing and weaving
motion simulate a live predator bird which frightens the bird immediately.
Scare Eye comes in three colors. Research show maximum effectiveness is
obtained by rotating colors. No color should be used for more than three weeks
or they will lose its effectiveness.
In the package, you will find a card with Mylar eyes. Remove the Mylar eyes
from the card and place them in the center of each black circle to form the
pupil. You will also find some Mylar streamers. Tie the streamers to the
bottom of the balloon with the enclosed string. You will also find a string to
attach to the top grommet.
WARNING : DO NOT OVER-INFLATE. DO NOT USE A COMPRESSOR. WITH HIGH
PRESSURE, THE SCARE EYE MAY BURST.
Gardens, Farm Fields, Berry Patches, and Vineyards
Attach the Scare Eye to any type of pole (wood, bamboo, PVC pipe) and install
it so that the Mylar tail is approximately 12″ above the highest plants. The
number of Scare Eye required is in direct proportion to the size of the plot.
In most cases, six per acre is a minimum.
Orchards & Trees
For maximum effectiveness, the Scare Eye should be installed above trees so
that the Mylar tail is approximately 12″ above the tree and very visible to
the birds. One Scare Eye per tree is usually sufficient.
The Scare Eye will move pest birds from decks, porches, swimming pools, boat
docks, homes, stores, and farm buildings. The Scare Eye is for use anywhere
bird problems exist outdoors. The Scare Eye does not work well indoors where
air currents are not available to move the balloon.
If you have a particular problem, call Bird-X at 1.800.662.5021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>