Electronic ESR 25W 3 in 1 Wireless Charger with MagSafe CryBoost User Manual
- June 13, 2024
- Electronic
Table of Contents
Electronic ESR 25W 3 in 1 Wireless Charger with MagSafe CryBoost
OVERVIEW
- MagSafe charging pad
- CryoBoost status light & vent
- Charger for Apple Watch
- AirPods charging pad
- CryoBoost on/off button
- AirPods charging status light
Status Light and Cooling Fan Guide
If charging stops or an error is detected:
- Ears that’s ur phone tapes sin es backing i met the wire charging.
- After checking the above, unplug and plug in the charging cable again to resume
Important Reminders
- Use the included adapter and cable to power the charger.
- Maximum output is 15W for iPhone, SW for AirPods, and 5W for Apple Watch.
- The AirPods charging pad only supports magnetic alignment for AirPods with MagSafe charging cases. AirPods with standard wireless charging cases can be charged wirelessly but will not be magnetically aligned.
- The MagSafe charging pad only supports magnetic attachment with caseless iPhones with Mag Safe (12 series or later), official Mag Safe cases, ESR HaloLock cases, or standard cases with a Hallock Universal King. It may not attach to other magnetic cases. It will not attach to any other non-magnetic phones or cases.
Safety Warnings
- Do not expose the device to temperatures below -20°C (-4°F) or above 60°C (140°F).
- Do not expose the device to an open flame or submerge it in water as this will damage the device.
- Always check for damage to the device, cables, or other accessories before using the device. If damaged, do not use the device.
- Do not attempt to disassemble or modify the device in any way, as it may cause serious damage and void the warranty.
- Do not expose the device to corrosive liquids, or high humidity as they will seriously damage the device and void the warranty.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, it is not installed and used in
accordance with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- reorient or relocate the recemna antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator &your body.
Declaration of Conformity
This product is intended for use within Europe. Electronic Silk Road Corp.
hereby declares that this product 2C571 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU,
2014/35/EU, 2014/30/EU. The Declaration of Conformity for the 2C571 is
available from www.esrgear.com.
Scan to watch a quick setup video:
esrgear.com/faq/2c571
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>