Jintai Electronic KEC-5000 Smart li Polymer Battery Pack Instruction Manual
- May 15, 2024
- Jintai Electronic
Table of Contents
Jintai Electronic KEC-5000 Smart li Polymer Battery Pack
Product Specification
Battery Capacity : S000mAh
Type-C Input : SV-2A
DC Output : SV-2A
Material : ABS+ PC
Size : 775913mm
Product weight : 110g
Conversion efficiency: 85%
Product instructions
- This product is used to power heating products, such as heating clothes, heating gloves, etc.
- Long press the power button to turn on, and long press to turn off.
- short press the power button after the boot can be adjusted, adjusted to see the attached table.
- See attached table for the power display.
figure lamp status
| LED display when charging | 0%-25% | Twinkle | Destroy | Destroy |
|---|---|---|---|---|
| 25%-50% | Bright | Twinkle | Destroy | |
| 50%-75% | Bright | Bright | Twinkle | |
| 75%-99% | Bright | Bright | Bright | |
| 100% | Bright | Bright | Bright |
| LED display when discharging | LED status | LED1 | LED2 | LED3 | LED4 |
|---|
Capacity percentage
Output 100%| Bright| Bright| Bright| Bright
Output 75%| Bright| Bright| Bright| Destroy
Output 50%| Bright| Bright| Destroy| Destroy
Output 25%| Bright| Destroy| Destroy| Destroy
Bluetooth connectionmethod
-
Mobile phone scan code download APP
-
After turning on the power switch of the product, operate on the APP and connect the Bluetooth to use it.
SafetyInstruction
- Please read the instructions and product surface words carefully before using.
- Please keep away from heat sources, high voltage or reachable for children when using the power bank,do not drop the product.
- Charging the power bank by USB to computer or adapter, charging time is no more than 24 hours.(Charging is finished when all indicators light and unplug the power bank).
- Please do not disassemble the product by yourself and keep away from damp place for safety.
- When out of service for long period, the power bank is better in half of power state and shouldbe stored in a dry and cold place.
- Waste power bank should be duly handle, do not put into fire or water.
ISED Canada Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada ‘s licence exempt RSS(s). Operation is subject to the following two conditions:
- this device may not cause interference and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canada radiation Exposure limits set forth for an uncontrolled environment to maintain compliance with IC’s RF Exposure guidelines. This device and its antenna(s) must not be co- located or operation in conjunction with any other antenna or transmitter.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2 : Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>