Honeywell ECS-50WBU Intelligent 50 Watt Power Amplifier Instruction Manual
- June 4, 2024
- Honeywell
Table of Contents
Honeywell ECS-50WBU Intelligent 50 Watt Power Amplifier
ECS-50WBU Installation Instructions
The ECS-50WBU provides backup capability when operating the ECS-DUAL50W in the 100 watt with backup mode for both single and dual channel setups.
Compatibility
The ECS-50WBU is compatible with the following Honeywell Farenhyt Series FACPs:
- IFP-2000ECS
- IFP-2100ECS
- IFP-1000ECS
- IFP-300ECS
- IFP-100ECS
Figure 1: Mounting Location for the ECS-50WBU
Mounting and Wiring
The ECS-50WBU mounts above the ECS-DUAL50W board on the standoffs provided.
- Remove AC power from the ECS-DUAL50W.
- Disconnect the backup batteries from the ECS-DUAL50W.
- Connect one end of the supplied wiring harness (P/N 50116775-001) from the connector labeled “Backup Amplifier” on the ECS-DUAL50W to the connector on the ECS-50WBU as shown in : Wiring Harness Connection.
- Using the 4 supplied screws, mount the ECS-50WBU to the standoff’s as shown in : Wiring Harness Connection.
- Restore AC Power.
- Reconnect backup batteries.
Figure 2: Wiring Harness Connection
Farenhyt™ is a trademark, and Honeywell® is a registered trademark of Honeywell International, Inc.
P/N LS10059-001SK-E Rev B ECN: 16-0218
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>