BORMANN BAN8016 Fine Crown Staple User Manual

: June 4, 2024
: BORMANN

Table of Contents

Safety Instructions
Tool Operation
Technical Data
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

BORMANN BAN8016 Fine Crown Staple

* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.

Safety Instructions

Do not attempt to operate the tool until you read and understand all safety precautions and manual instructions.
Never allow to use oxygen or combustible gas as a power source for the tool Use filtered, lubricated, regulated compressed air only.
Never use gasoline or other flammable liquids to clean the tool. Vapours in the tool Mill ignite by a spark and cause the tool to explode.
Do not exceed maximum permissible operating pressure 7.8bar (115 psi).
Any tool equipped with contact actuation with a safety yoke shall not be used -if changing one driving location to an other involves the use of stairs, ladders or scaffolding for closing boxes or crates and for fitting transportation safety systems.
Disconnect the tool from air supply before clearing jams performing repairs and during non-operation
Do not keep the trigger pulled on safety yoke mechanism when carrying or holding the tool.
Never carry the tool by the hose or pull the hose to move the tool. Carry the tool only by the handle.
At the workplace, always wear the protective equipment such as safety and head protection.
Do not use a check valve or any other fitting that allows air to remain in the tool.
Never point any operational fastener driving tool at yourself or at another person.
Protect your eyes and ears.
Wear safety glasses.
Check and replace any damaged or worn components on the tool.

Tool Operation

Add a few drops of suitable recommended oil into the air inlet.
Install a quick-connect fitting to the tool.
Connect the tool to an air compressor using a 3/8” I.D hose. Make sure the magazine must be empty of all fasteners and the hose has a rated working pressure exceeding 200 psi (13.8 bar) and a female quick coupler.
Regulate the air pressure to obtain 62 psi(4.1 bar) at the tool. Check the operation of the safety yoke mechanism following the instructions in this manual.
Insert fasteners into your tool following the instructions of loading the tool.
Reconnect the hose to the tool.
Test for proper fastener penetration by driving fasteners into a piece of wood. If the fasteners do not achieve the desired penetration, regulate the air pressure to a higher setting until the desired penetration is achieved. Do not exceed 7 bar(100psi) at the tool.

Removing a jammed fastener from the Tool