PERIMETER BILLIARD 1668141167 LED Pool Table Light Instruction Manual
- June 13, 2024
- PERIMETER BILLIARD
Table of Contents
PERIMETER BILLIARD 1668141167 LED Pool Table Light
Dimension
Parts
ASSEMBLY
Step 1
Step 2
Don’t fully screw, leave 2 mm gap
Step 3
Suggest Light height: 75-85 inch from floor.
Step 4
Locate sturdy ceiling joist first, then use screw E attach Part J to the
ceiling.
Step 5
Connect suspension cable from step 3 to the ceiling.
Step 6
Repeat step 1 to step 5 up to 8 suspension cables.
Final result should look like below.
Step 7
Total 8 suspension cables, 4 on each long side
Step 8
Prepare to attach 6 pieces LED light to suspension cables. Place number 1 and
6 on the same side, 3 and 4 on the other side. Place number 2 & 5 as shown in
the pie.
Step 9
Slide the end of suspension cables into the top of light.
Install two long sides first.
Step 10
Once finished attaching two long sides to the suspenson cables, use part Ax2,
Dx8 to cennect each joint.
Step 11
Once finished two Long sides, connect two short sides to the long side.
Use part Bx1 , Cx1, Dx8 to connect each joint on the corner.
Step 12
Adjust final height by using level tool.
Recommend light height is 75-85 inch from floor, or 45-55 inch from table
cloth.
Step 13
Use 16 awg electrical wire (part L) to wire each LED light, in the order of
number 1 to 6 with ANTI-CLOCK direction, make sure to connect tight.
Step 14
You can either plug the light into a outlet, or remove the 2-pole plug to
hardwire it into a switch control.
If you are going to use plug in, highly recommend to buy a remote control
outlet to use remote turn on/off the light.
www.PerimeterBilliardLights.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>