prescolite LBSES-6SQD-CS9-WH 6 Inch Square LED Surface Mount Downlight Module Instruction Manual

June 13, 2024
prescolite

prescolite LBSES-6SQD-CS9-WH 6 Inch Square LED Surface Mount Downlight Module Instruction Manual

prescolite LBSES-6SQD-CS9-WH 6 Inch Square LED Surface Mount Downlight
Module Instruction Manual

⚠ IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Follow label information and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or revamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition. Fixtures are suitable for use in clothes closets per NEC 410.16(C)(1). Fixtures are not suitable for installation into clothes closet storage spaces as defined by NEC 410.2.

Step 1
Attach J-Box mounting plate (with spring tabs up) to compatible existing J-Box with screws provided.
For Square Apertures: Orient plate with spring tabs parallel to the wall for proper alignment.

Step 2
Make wiring connections using provided wire nuts:

Black → Line (Hot)
White → Neutral
Green → Ground
Purple → 0-10V Dim (+)
Gary or Pink → 0-10V Dim (-)

  • For 0-10V dimming only

For LBSES models: Select the desired CCT color temperature (27K/30K/35K/40K) using the switch on driver.

Step 3
Push wire connections up into J-Box aligning fixture springs with mounting plate spring tabs. Push fixture to the ceiling to securely snap into place. Do not pinch wires!

SAVE THESE INSTRUCTIONS!

© 2022 HLI Solutions, Inc. All rights reserved. currentlighting.com/Prescolite
Technical Support: 888.777.4832

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals