Sonnax T35-28-350CFK Splined Stub & Sleeve Kit User Manual

June 13, 2024
sonnax

Sonnax T35-28-350CFK Splined Stub & Sleeve Kit User Manual
Sonnax T35-28-350CFK Splined Stub & Sleeve Kit

Package Content

  • Yoke/Stub Shaft
  • Splined Sleeve
  • Boot
  • Boot Clamps (2)

NOTE: For use with 3.5″ ID carbon fiber tubing.

Overview

Overview

Dimension

  1. Install slip spline assembly into mating driveshaft tube.
  2. Measure runout of assembled shaft, adjust if necessary and bond according to builder preference.
  3. Balance shaft in accordance with standard build procedures.
  4. Separate yoke shaft from splined sleeve.
  5. Apply a light, even coating of grease to yoke shaft splines. The following greases are recommended:
    • TriboGel® PA6110LCS synthetic grease
    • Chevron® Ultra-Duty EP-2 grease (NLGI Grade 2)
    • Spicer® 232799 Ultra-Duty EPS Multi-Purpose grease
  6. Reinstall yoke shaft in splined sleeve, along with the protective boot included with the kit, taking care to ensure the phasing witness marks on yoke shaft and sleeve are aligned (Figure 1).
  7. Recommended installation setup length and minimum/maximum operating lengths:
    a. The recommended installation setup length (mid-stroke) is 4.16″ (Figure 1).
    Dimension
    b. The recommended minimum collapsed operating length is 3.41″ (Figure 2).
    Dimension
    c. The recommended maximum extended operating length is 4.91″ (Figure 3).
    Dimension

©2023 Sonnax Transmission Company, Inc.
A Marmon /Berkshire Hathaway Company
800-843-2600
802-463-9722
F:802-463-4059
www.sonnax.com

Sonnax logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals