Ferguson MCC Medium Tubing Cutter Instruction Manual
- June 13, 2024
- Ferguson
Table of Contents
Ferguson MCC Medium Tubing Cutter
1 1/4″ TUBING CUTTER SAFETY AND INSTRUCTION MANUAL
Specification
Materials to be cut | Copper Tubing, Stainless Steel Tubing |
---|---|
Capacity in O.D. | MIN. 3/16 inch (4mm)- MAX. 1.1/4 inch (32mm) |
Capacity in Wall Thickness | Max. 0.118 inch (3mm) |
Safety/Warning Precaution
WARNING
SHARP! Do not touch the cutter wheel or cut end directly with finger or hand.
It could cause injury.
CAUTION
- Always check the material and capacity to be cut. Never attempt on any materials except specified.
- Be sure to keep all bolts, nuts and pins on your MCC Tubing Cutter properly tightened at all times.
- Always keep the moving parts on your MCC Tubing Cutter well lubricated. Use grease for bearing lubrication.
- Keep the cutter wheel with right angle on the materials when cutting. Do not twist the cutter.
Instructions
Open the cutter wheel by turning the knob counterclockwise. Feed the cutter
wheel until firm contact to cutting surface is made. Firmly tighten feed knob
every revolution until cut is made.
NOTE: For less burr, use more gradual feed. For long life time of cutter wheel, avoid twisting the cutter.
Replacement Wheel
MCC Replacement Cutter Wheel, TCE32 is available with bearing.
MCC Corporation www.mccinter.com Distributor for your country/region
For United States of America I MCC USA INC. www.mccusajnc.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>