Ferguson 2390716 PVC Pipe Cutter Instruction Manual

June 13, 2024
Ferguson

Ferguson 2390716 PVC Pipe Cutter

Ferguson 2390716 PVC Pipe Cutter

Introduction

This manual provides the user with basic operating and safety instruction about this product
For your own safety, carefully read this manual before use and learn the potential hazards. This product is designed for one-handed cutting of plastic pipe with ratchet action.

Capacity & Materials to be cut

Use this product only on the following materials and capacity.

  • Materials to be cut: PVC. CPVC, PE, PEX, ABS pipe Information for use on other materials, please contact your distributor or MCC customer service.
    Cutting Capacity (Pipe 0.D.) up to 1 5/8″ (42 mm)

WARNING

Sharp! Do not touch the blade or blade edge with fingers or hands. Wear protective gloves and glasses during operation or maintenance.
Do not touch the ratchet gear while operating in order to avoid pinching your finger or hand.

CAUTION

Always check materials and diameter to be cut. Never cut materials other than as described.
Do not twist the cutter or pipe while cutting otherwise it may cause damage to blade. Before cutting work, remove any mud or foreign objects on the pipe in order to avoid any damage to the blade. Do not hang the cutter only by a hook in order to prevent it from falling and breaking.
Throwing, dropping, or any other rough handling of the cutter may cause breakage or damage to the cutter.
For maximizing the tool life, maintain the cutter in good working condition and never operate the cutter with any damage.

How to Operate

First clean the pipe to be cut. remove any objects on the pipe.

  1. Unhook the handles and open the handles & blade. Tuck the hook into the handle while operating. Place a pipe in the jaw.
    Hot to operate

  2. Keep ratcheting (; open handle and close repeatedly) feeling each ratchet click until cut is completed. Wide open handle will release blade.
    Hot to operate

  3. Reaming & deburring can be done using the hole on the blade. This is only for outside edge of pipe.
    Hot to operate

To properly cut old pipes or pipe in cold temperature, warm up the pipe and cut very slowly to avoid cracking or shattering the pipe.

For thin wall PVC pipe such as Class 200, flighty squeeze the handles while rotating them up and down when the blade edge just starts cutting into the pipe. This helps the blade to penetrate the wall of pipe without deforming the pipe.

Replacement Blade

Periodical replacement of blade prolongs the lifetime of tool. It becomes very economical in the long run by doing so.
Use only the blade listed below.

  • Model No. VCE0342 (Replacement blade for VC-0342)

Customers Support

MCC Corporation www.MCCinter.com

US Sales Office
MCC USA INC. www.MCCusainc.com

Distributor for your country/region

WARNING
This product can expose you to chemicals including Ethylbenzene, which 1s known to the State of Colombia to cause cancer.
For more information, go to www.P65Warnings.ca.gov.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals