CyberPower P304UC3 3 Outlet Surge Protector Instruction Manual

: June 13, 2024
: CyberPower

Table of Contents

FEATURES
SPECIFICATIONS
FOR MORE INFORMATION
TECHNICAL SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

YOUR ULTIMATE ALLY IN POWER
3 OUTLET
SURGE PROTECTOR
WITH 3 USB-C PORTS
P304UC3 CyberPower P304UC3 3 Outlet Surge
Protector

FEATURES

Standard Grounded Outlets (3)
USB-C Charging Ports (3)
Connect and charge up to three (3) USB devices using the surge protected USB charging ports.
USB outlets cannot be used as a USB hub. This device does not transfer data.
Power Cord

SPECIFICATIONS

Model Number:	P304UC3
Outlets:	3 Standard Grounded Outlets
USB Ports:	3 USB-C Charging Ports
Power Cord Length:	4 ft
Surge Protection:	500 Joules
Electrical Rating:	125 V/15 A/1875 W
UL Clamping Voltage:	UL 1449 4th/900 V (L-N)
Maximum Peak Current:	15,000 A
1 AC Line Protected:	L-N: 15,000 A

(The maximum surge possible on household wiring is 6,000 volts)
Response Time:| Less than 1 nanosecond
USB Charging Rating:| 5 V/3 A Max
USB Total Output: 30 W

WARNING: This product can expose you to chemicals including Styrene, which is known to the State of California to cause cancer, and Bisphenol A (BPA), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK:
DO NOT plug into another relocatable power tap.
DO NOT “daisy chain” surge protectors.
DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not available.
DO NOT install this device if there is less than 10 meters (30 feet) of wire between the electrical outlet and electrical service panel.
DO NOT use for medical or life support equipment. This device features an internal protection that will disconnect the surge protective component at the end of its useful life, but it will maintain unprotected power to the load.

FOR MORE INFORMATION

Visit CyberPowerSystems.com for more information regarding:

Product information and certification
Product warranty
Connected equipment guarantee

TECHNICAL SUPPORT

Visit: CyberPowerSystems.com/support
Toll-Free: 1-877-297-6937
© 2023 Cyber Power Systems (USA), Inc. All rights reserved.
All other trademarks are the property of their respective owners.
CONFORMANCE APPROVALS
This device complies with Part 15 of the FCC Rules.
Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400
Shakopee, MN 55379
CyberPowerSystems.com