SALUS TS600 TS600 Secure Thermostat User Guide
- June 5, 2024
- SALUS TS600
Table of Contents
Model: TS600
Quick Guide
Introduction
TS600 is a multi-functional device that can be configured to be a programmable room thermostat or a hot water timer built into a smart designed casing and it is compatible with the SALUS Smart Home system.
Product Compliance
This product complies with the essential requirements and other relevant
provisions of Directives 2014/53/EU and 2011/65/EU. The full text of the EU
Declaration of Conformity is available at the following internet address:
www.saluslegal.com
2405-2480MHz; <14dBm
Safety Information
Use in accordance with the regulations. Indoor use only. Keep your device completely dry. Disconnect your device before cleaning it with a dry cloth.
Box content
Front case Back case
2x fixing scews Quick Guide
2x 2AA alkaline batteries
Mounting
1 An external sensor can be connected to the S1 and S2 terminals. Purchased separately.
2 Mount the back case on the wall.
3 Insert the batteries. TS600 will automatically go into pairing mode.
4 Add the front case.
LED Indication
| LED | Meaning |
|---|---|
| Red LED on for 5 seconds | Factory Reset |
| Green LED flashes 0.25s on and 0.75s of | Identify Mode |
| Red LED flashes 0.3s on and 0.3s off (3.5s off last cycle) for 10 minutes |
Joining network
Amber LED flashes 0.3s on and 0.3s off (3.5s off last cycle) for 10 minutes|
Pairing device
Green LED on for 0.5 seconds| Calling heat/cool if the button is pressed
Red LED on for 0.5 seconds| No calling heat/cool if the button is pressed
Red LED flashes 3 times every 10 seconds| Low Battery
Red LED flashes 4 times every 10 seconds| Lost link with parent
Red LED flashes twice every 10 seconds| Error
Pairing
Follow the onscreen instructions to complete the setup.
Button operation
Touch sensor area
Press the touch button to see the status of the device. If TS600 is
calling for HEAT, the LED will be GREEN. If TS600 is SATISFIED, the LED will
be RED.
If TS600 is paired, press and hold the touch button for 3 seconds. TS600 will
enter Identify mode and will send Identify command to all related devices.
TS600 can be locked or unlocked via the app. To unlock the device manualy, you
need to reset the device first and then press and hold the touch button for 10
seconds during the first minute after reboot. The device will reset again and
unlock.
To perform a reset , press and hold the touch button for 10 seconds. The
LED will turn red for 5 seconds. TS600 will leave the network and reset. Once
completed, the TS600 will re-enter pairing mode.
PRODUCER:
Salus Limited
6/F, Building 20E, Phase 3, Hong
Kong Science
Park, 20 Science Park East
Avenue, Shatin,
New Territories, Hong Kong
IMPORTER:
QL CONTROLS Sp. z o.o. Sp. k.
ul. Rolna 4, 43-262 Kobielice
SALUS Controls is a member of the Computime Group
Maintaining a policy of continuous product development SALUS Controls plc reserve the right to change specification, design and materials of products listed in this brochure without prior notice.
Issue date: 2021 01
Version: V001
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>