SCOSCHE PBQ5MS2 Power bank Instructions
- June 13, 2024
- Scosche
Table of Contents
SECTION D
A. USB-C Input Charging
Use the included cable to charge GoBat with a USB-C charger or power source
(not included).
B. USB-C Output Charging
GoBat’s USB-C port can charge other devices using the included cable or the
device’s USB-C charge cable. Note: Wireless charging and USB-C output cannot
be used at the same time.
SPECIFICATIONS
Battery Capacity: 5,000 mAh
USB-C Input: 5V 2A
USB-C Output: 5V 2A
Wireless Output: 10W Max.
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, induding interference that may cause undesired operation. Warning: changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instuctions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Inaease the separation between the equipment and receiver.
- Connect the equipment into an outlet on a draft different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/Ntechnidan for help.
Canadian Compliance Statement This device contains licence-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions: (1)This device may not cause interference.(2)This
device must accept any interference, including interference that may cause
undesired operation of the device.
Tit debiice complies with pat 15 of the FCC Rules Operation is subject to the
folloning two conditions (1) This device may rot cause harmful interference.
and (2) this device must accept any interference received induding
interference that may case undesired operation.
FCC warning:
My Chaves or modifications not emressfy approved by the parry responsible for
compliance wtki void the user’s authority to operate the equipment
Note: This equipment has been tested and found to comply with the limits
for a Class Sdigital device. pursuant to part 15 of the FCC Rules These limas
are descried to provide reasonable protection against hamffil interference in
a residential installation. Ths eqqprnent generates uses and can radote radio
frequency energy and. if not ristalled and used n accordance with the
instructions. may cause harmffI interference to radio communicators HoAever.
there S no guarantee that interference will not occur n a particular
installation. if ths equipment does cause harmfil interference to radio or
televison reception Mich can be determined by tuning the equipment off and on.
the user is encouraged to try (0 Or ea the bterference by one or more of the
following measures
- Reorient or relocate the recevio antenna.
- Increase the separation between the equipment and recaver.
- Connect the equipment into an outlet on a mut different from that to which the receiver s connected.
- Consit the dealer or an everenced radio /TV technician for help
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
GoBat MS 5K How-To Video …https://qrco.de/bdfBh1
Scosche Industries
1550 Pacific Avenue
Oxnard, California 93033
Phone: 800-363-4490 x1 / 805-486.4450
x1
www.scosche.com
©2023 Scosche Industries
Scosche and GoBat are trademarks of Scosche Industries.
Other marks or brands are the property of their respective owners.
Devices and or appearance may vary.
Designed in Oxnard, California
SI PBQ5MS2 3/23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>