SCOSCHE SM21010 18 Panoramic Rearview Mirror Instructions
- June 13, 2024
- Scosche
Table of Contents
Register your product online at
www.scosche.com/register
SCDSCUE” PSM21010
18″ PANORAMIC REAR-VIEW MIRROR
PARTS INCLUDED **
**
(1) 18″ Panoramic Rear-view Mirror w/ Mounting Base
TOOLS REQUIRED (Not Included)
3/16″ Hex (Allen) Key, Except where noted
SM21010 18 Panoramic Rearview Mirror
VARIOUS RING ClAMP SIZES SOLO SEPARATELY w/ HARDWARE”
PSC21006 – BaseClamp 1.5″ Ring Clamp
PSC21007 – BaseClamp 1.625″ Ring Clamp
PSC21009 – BaseClamp 1.75″ Ring Clamp
PSC21010 – BaseClamp 1.85″ Ring Clamp
PSC21011 – BaseClamp 1.875″ Ring Clamp
PSC21012 – BaseClamp 2″ Ring Clamp
PSM21009
18″ PANORAMIC REAR-VIEW MIRROR INSTRUCTIONS
STEP 1
Choose a mounting location (A)
STEP2
Position & mount the 18″ Panoramic Rear-View Mirror to the appropriate sized
clamp rings for the vehicle by clicking clamp ring into the base (B). Then use
a 3/16″ hex key to fasten the screw & nut included with the clamp (C). Do not
fully tighten yet.
STEP3
Use the 3/16″ hex key to adjust the mirror’s position (D).
STEP4
Once positioning is complete, tightening both adjustment screws (C & D).
Continue until clamp is tight and does not move.
Note: Do not exceed 200 inch-pounds.
STEPS
Check mirror position and untighten, adjust & re-tighten if needed.
Clamp Removal:
In-order to remove the clamp from location, the clamp must first be tightened
to allow base removal. Once tightened, loosen the clamp and carefully squeeze
clamp to remove from the location. Note: Use protective film to help avoid
damage to the paint. * Various ring clamp sizes available (sold separately w/
hardware).
BASE-CLAMPS HOW IT WORKS:
STEP 1
Select the right size clamp (Various sizes sold separately)
STEP2
Select the base & ring clamp that coincides with what you need to mount 2A.
Use protective film to prevent any paint damage 2B.
STEP3
Lock it in place
The self locking clamp design allows for easy one person installation. Simply
slip the clamp over tube and lock in your base, secure using the stainless
mounting hardware and you are ready to Mount Up and Move Out. 
NOTE: Ring clamps 2″ & over in size may require pre-stretching to help
spread the clamp over the tube. (Use Protective film when mounting)
For complete warranty details, please visit us at
www.scosche.com or call
800-363-4490
References
- Scosche Tech Accessories | #1 Mount Brand in US & Canada
- Product registration | Register your purchase
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>