camry CR 4415 Electric Coffee Maker User Manual

June 13, 2024
camry

CR 4415
user manual

CR 4415 Electric Coffee Maker

GENERAL SAFETY CONDITIONS IMPORTANT SAFETY INSTRUCTIONS. PLEASE READ CAREFULLY AND SAVE FOR FUTURE

  1. Before using the device, read the operating manual and follow the instructions contained in it.

  2. The device is for home use only. Do not use for other purposes that are not for its intended purpose.

  3. The device should only be connected to a 230V~50 Hz grounded socket. To increase operational safety, multiple electrical devices should not be connected to one current circuit
    at the same time.

  4. Use extreme caution when using the device when children are nearby.

  5. WARNING: This equipment may be used by children over 8 years of age and people with reduced physical, sensory or mental ability, or people who have no experience or knowledge of the equipment, if this is done under the supervision of a person responsible for their safety or have been granted them information on the safe use of the device and
    are aware of the dangers of using it. Children should not play with the equipment. Cleaning and maintenance of the device should not be performed by children, unless they are over 8 years old and these activities are carried out under supervision.

  6. Boil the water in the tank and pour it twice to get rid of the smell before first use.

  7. Always remove the plug from the power socket after use by holding the socket with your hand after use.

  8. When removing the plug from the socket, never pull the power cord but the plug.

  9. Do not expose the device to atmospheric conditions (rain, sun, etc.) or use in conditions of high humidity (bathrooms, damp mobile homes).

  10. Do not immerse the cable, plug and the device in water or any other liquid.

  11. Periodically check the condition of the power cord. If the power cord is damaged, it should be replaced by a specialist repair shop to avoid danger.

  12. Do not use the device with a damaged power cord or if it has been dropped or damaged in any other way or if it is not working properly. Do not repair the device yourself, as there is a risk of electric shock. Take the damaged device to an appropriate service center for checking or repair. All repairs may only be carried out by authorized service
    points. Incorrectly performed repairs can cause serious danger for the user.

  13. Place the device on a cool, stable surface, away from hot kitchen appliances such as: electric stove, gas burner, etc.

  14. Do not use the device near flammable materials.

  15. The power cord may not hang over the edge of a table or touch hot surfaces. The manufacturer is not liable for damages caused by using the device contrary to its intended purpose or improper operation. Do not allow children to play with the device, do not allow children or people unfamiliar with the device to use it.

  16. Do not leave the device switched on or the adapter unattended when unattended.

  17. To provide additional protection, it is advisable to install a residual current device (RCD) in the electric circuit with a rated residual current not exceeding 30 mA. Ask an electrician for this advice.

  18. Never use the device without water! It may be damaged.

  19. Never use the device with sparkling water !!!

  20. Never leave the device at a temperature below 0 degrees Celsius, as it may damage it.

  21. Always unplug the machine before filling the tank with water.

  22. Regularly clean and inspect the machine to ensure the quality of coffee obtained and to extend the life of the machine.

  23. Always disconnect the power source before cleaning and allow all hot parts to cool down. The device should be cleaned with a mild non-abrasive detergent. Never use cleaning solvent as this could damage the paint layer.

  24. For descaling the machine, use a liquid descaler designed for pressure coffee makers.

  25. Use only original accessories.

  26. Do not move or move the device during operation.

Device description Moka maker:

A. Lid
B. Top tank
C. Bottom tank
D. Base
E. Power cord
F. On / Off switch
G. Light indicator
H. Safety Valve
I. Funnel filter
J. Disc Filter
K. Gasket for upper disk filter
L. Upper Disk Filter

Preparing the device for use.

  1. Remove all packing material from the device.
  2. Rinse the inside of the Top tank (B) and Bottom tank (C) with water making sure the water does not overflow.
  3. Use a dry paper towel to dry the device both inside and outside making sure the area between the Base (D) and the Bottom tank (C ) is dry.

Please note this device is for making coffee. Do not use any other extracts, cocoa powder, herbs, flowers, sugars, infusions soluble substances, or other substances that might block the holes in the device filters.
Never immerse the base and the boiler in the water while cleaning.

Using the device:

  1. Check if the device is not hot from previous use.

  2. Grasp the Top tank (B) with a dry hand and do not press or pull on the handle.

  3. Grasp the Bottom tank (C ) with your other hand.

  4. Twist the Top tank (B) counterclockwise until you unscrew the Top tank (B) from the Bottom tank (C ) making sure not to press or pull on the handle.

  5. Once you open the device take out the Disk Filter (J) and the Funnel filter (I).

  6. Fill the Bottom tank (C ) with water. The water level should not reach the Safety Valve (H).

  7. Insert the Funnel filter (I) into the bottom tank.

  8. Fill the Funnel filter (I) with ground coffee to around 4/5 of its capacity.

  9. Put the Disk Filter (J) with the little button facing upward. The Disk filter is designed to keep the coffee ground in the Funnel filter. If not used small parts of the coffee ground can end up in the finished coffee brew.

  10. Screw the Top tank (B) back on top of the Bottom tank (C). Make sure not to press or pull on the handle.

  11. Put the assembled device onto the Base (D).

  12. Press the ON / OFF button (F). The Light indicator (G) will turn on.

  13. The Moka maker will start brewing.

  14. After some time the Moka maker will start to bubble and prepare the coffee.
    (Do not open the lid (A) until the Moka maker if finished brewing. You might get burned with hot steam and hot coffee.)

  15. Once the bottom tank (C ) is empty turn off the device with the On / OFF switch (F). (You will know it is empty as the coffee will not flow anymore and the noise the device is making will be much lower.)
    WARNING Please turn off the device with the ON / OFF switch (F) after each use.

  16. Grab the device by the handle and pour the coffee into prepared cups.

Cleaning:

  1. Check if the device hot from previous use. Cleaning should be done only after the device has cooled down completely.
  2. Once the device is cool.
  3. Grasp the Top tank (B) with a dry hand and do not press or pull on the handle.
  4. Grasp the Bottom tank (C ) with your other hand.
  5. Twist the Top tank (B) counterclockwise until you unscrew the Top tank (B) from the Bottom tank (C ) making sure not to press or pull on the handle.
  6. Once you open the device take out the Disk Filter (J) and the Funnel filter (I).
  7. Empty the Funnel filter (I) and clean it with water and a paper towel removing the used coffee ground.
  8. Clean the Disk Filter (J) with water and a paper towel.
  9. Empty the remaining water from the Bottom tank (C ) and clean the inside of the tank with a soft towel, washing up liquid and water, and then dry with a paper towel.
  10. Clean the Upper disk (L) and the Gasket (K) with a paper towel.
  11. Clean the Top tank (B) with water, washing up liquid, and a paper towel.
  12. Leave the device to dry and then assemble it back before storage.

Changing the Upper disk and Gasket:
After some time the Gasket (L) and upper disk (K) will deteriorate. The gasket will start to fall apart and the filter will discolor or lose its shape. TO exchange,
To exchange the Disk and Gasket:

  1. Check if the device hot from previous use. Exchange should be done only after the device has cooled down completely.
  2. Once the device is cool.
  3. Grasp the Top tank (B) with a dry hand and do not press or pull on the handle.
  4. Grasp the Bottom tank (C ) with your other hand.
  5. Twist the Top tank (B) counterclockwise until you unscrew the Top tank (B) from the Bottom tank (C ) making sure not to press or pull on the handle.
  6. On the bottom side of the Top tank (B) you will see a round rubber gasket and a metal filter.
  7. Using a thin blade lift the gasket downwards releasing it from its place along with the upper disk.
  8. Dispose of the old gasket and upper disk.
  9. To install put the metal disk in the middle of the empty space with the bulge of the filter facing you.
  10. Push the new gasket around the filter and then using your finger move the gasket around the new filter until it falls into place.
  11. You can screw the Top tank back on to see if the gasket is in place.

WARNING: Please note that both the Rubber gasket (K) and the Upper disk (L) are consumable parts and are not covered by the device warranty. Ask your local seller for the availability of the spare disk and gasket. (CR 4415.1 disk and gasket set.)
TIP: After changing the gasket the rubber might change the taste of the coffee depending on the coffee acidity it is advised to make a few cups of either just water or used coffee grounds to remove the taste off the rubber.

Troubleshooting:

Problem: No coffee in Top Tank (b)
Cause: No water in the Bottom tank (C).
Solution: Add water to the Bottom tank (C)

Problem: Coffee making takes a long time.
Cause: Bad coffee type. Too coarse or too fine. The filter is blocked.
Solution: Use special coffee for Mocca. Clean the top filter.

Problem: Coffee dripping from the sides of the bottom tank (C).
Cause: The top filter is blocked. The gasket is burned or broken.
Solution: Clean the filters. Exchange the gasket.
Technical details: Voltage: 220 – 240V ~ 50/60 Hz
Power: 480 W
Capacity: 300 ml

Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container Worn device should be returned to the appropriate point storage because it is dangerous in the device ingredients may pose a threat to the environment. The electrical device should be handed over to limit its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.

camry CR 4415 Electric Coffee Maker - Product Overview
2 camry CR 4415 Electric Coffee Maker -
Product Overview 4

www.camryhome.eu

AFTER SALE SERVICE NOTICE
If you want to buy spare parts or make any complaints, please contact the seller who issued the receipt directly.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals