Bailey 0-70W Electronic Transformer Installation Guide
- June 13, 2024
- Bailey
Table of Contents
Bailey 0-70W Electronic Transformer
Product Information
The TOPO Electronic Transformer is designed for 12V lamps with a power range of 0-70W. It has a primary voltage range of 220V-240V and a secondary voltage of 11.5V. The transformer is dimmable and compatible with both halogen and LED lamps. It can be dimmed using most leading/trailing edge dimmers. The transformer has an IP20 rating, meaning it is protected against solid objects larger than 12mm but is not protected against water.
Product Usage Instructions
- Before installation, read the specifications to ensure the product is suitable for the operating environment.
- This electronic transformer is compatible with both 12V halogen and LED lamps.
- The transformer must be installed above insulation.
- For wet applications, use an IP rated fixture.
- Installation should be done by a qualified professional.
- Install the transformer in places with good airflow and away from heat sources.
- The dimmer should be installed on the power input wire leading to the transformer.
- If flickering or noise occurs, it means the transformer is not compatible with the used LED lamp and/or LED dimmer.
Please note that specific dimensions, weight, and other details are not provided in the user manual. Refer to the manufacturer’s website or contact Bailey Electric & Electronics for more information.
INFO
Before installation please read the specifications to make sure that this product is suitable for the operating environment.
- This dimmable electronic transformer is compatible with 12V halogen and LED lamps!
- Dimmable with most leading/trailing edge dimmers.
- Transformer must be installed above insulation.
Specifications
- Primary voltage range 220-240V
- Frequency 50/60Hz
- Input current 0.29A
- Secondary voltage 11.5V
- Output current (full load) 6.0A
- Power range 0-70W (Halogen) 0-45W (LED)
- Output frequency 32~38KHz
- Efficiency >93%
- Power factor >0.99
- Input capacitance 100nF
- Ambient temperature (ta) 50°C
- Max. case temperature (tc) 80°C
- Dimming R,C & R,L,C
- Dimensions L x W x H 113x44x28mm
- Weight 110g
- Primary terminal 2-pole, screw dia 5.2mm
- Input wire cross section 0.75-2.5mm²
- Secondary terminal 2-pole, screw dia 3.2mm
- Output wire cross section 0.75-2.5mm²
- Secondary cable length (min-max) 30-200cm
- Housing material PC
- Safety class II
- Overload protection √
- Short ciruit protection √
DIMENSION
Wiring scheme
Standards
- EN 61347-1
- EN 61347-2-2
- EN 62493
- EN 55015
- EN 61000-3-2
- EN 61000-3-3
- EN 61547
Warning – Caution
- Risk of electric shock. Disconnect power before installation, servicing and removal.
- All safety instruction must be followed to avoid a risk of injury or property damage.
- Wet applications require an IP rated fixture.
- Installation should be done by a qualified professional.
- Install transformer in places with good air flow and away from heat sources.
- Dimmer should be installed on power input wire leading to transformer.
- If flickering or noise occurs it means the transformer is not compatible with used LED lamp and/or LED dimmer.
CONTACT
- Bailey Electric & Electronics bv
- Everdenberg 21 4902TT
- Oosterhout The Netherlands
- +31 (0)162 52 2446
- www.bailey.nl.
TOPO Electronic Transformer for 12V lamps 0-70W Primary 220V-240V, Secondary 11.5V, IP20
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>