KALORIK 51008 30-Piece 6-Arm Brushes Complete Refresh Kit Instruction Manual

KALORIK 51008 30-Piece 6-Arm Brushes Complete Refresh Kit

INCLUDES

• 2x HEPA Filters
• 2x Copper Filters
• 2x Sets of Side Brushes 20x Aroma Pads
• 1x Roller Brush
• 1x Sweep Guard
• 2x Cleaning brushes

INSTRUCTIONS – FILTERS

1. Make sure HUVI is switched off, then remove the dust container.
2. Open the dust container and remove the old HEPA filter and copper filter components. Dispose of the old filters.
3. Align a new HEPA filter with the bottom of a new copper filter, then insert the assembled piece into the dust container.
4. Close the dust container, then attach the dust container to HUVI.

CARE & CLEANING – FILTERS

1. Remove and open the dust container.
2. Remove the HEPA filter and copper filter components.
3. Clean the dust container and filters with the cleaning brush or by hand.
4. Put the filters back together in the dust container, then reinsert the dust container into your HUVI.

INSTRUCTIONS – ROLLER BRUSH & SWEEP GUARD

1. Make sure HUVI is switched off.
2. Push the two release tabs to unlock the sweep guard, then lift the roller brush to remove. Dispose of the old sweep guard and roller brush.

3. Install the new roller brush by inserting the fixed protruding end first so that the brush clicks into place.
4. Attach the new sweep guard. Press down to snap the sweep guard into place.

CARE & CLEANING – ROLLER BRUSH & SWEEP GUARD

1. Remove the roller brush and sweep guard.
2. 2. Clean the roller brush as well as the suction intake with the provided cleaning tool or by hand to remove any debris or obstructions.
3. Reinstall the roller brush by inserting the fixed protruding end first so that the brush clicks into place.
4. Reattach the sweep guard. Press down to snap it into place.

INSTRUCTIONS – AROMA PADS

1. Push down on the aroma diffuser compartment until it softly clicks and opens.
2. Remove the tray and pad inside. Dispose of the old oil pad.

3. Place a few drops of aroma or essential oil of your choosing on one of the new pads.
4. Place the new pad inside of the tray, then reinsert the tray into the oil diffuser compartment until it clicks in place.

NOTE: Do not reuse or clean pads. A fresh pad should be used whenever oil needs to be replenished.

INSTRUCTIONS – SIDE BRUSHES

1. Make sure HUVI is switched off. Gently but firmly remove the old brushes (Fig. A), then dispose of the old brushes.
2. Attach the new side brushes by pressing the brush into each slot until it clicks. Make sure to match the letter on the brush with the letter on HUVI (Fig. B).

CARE & CLEANING – SIDE BRUSHES

1. Remove the side brushes from HUVI. Carefully remove any debris wrapped between the main unit and the side brushes.
2. use a cloth dampened with warm water to remove any dust from the brushes or to gently reshape them.
3. Allow the brushes to fully dry before reattaching.

CONTACT US: If you have any questions or concerns, or are unhappy with your product, please reach out to us at SERVICE@KALORIK.COM, or by phone at our toll-free number: +1 888-KALORIK.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>