Kessil W360 Outdoor Landscape Light User Guide
- June 13, 2024
- Kessil
Table of Contents
W360/W500
User Guide
W360/W500 Setup (TOX/TON)
-
Push & Lock Track Adapter into the Track
• Insert the adapter into the track, so that the mechanical key (B) in the adaptor matches the groove (A) in the track. Rotate the locking level (C) about 90 degrees until it reaches the lock position.
• Use Knob D to select the circuit the lamp will draw power from -
Connect the Power Cord
• Connect the power supply DC cord to the light fixture.
• Once assembly is complete, turn on track power and turn the intensity knob on the light fixture to confirm it is operational.
• Adjust the fixture to the desired angle using the ball joint.
DMX Addressing Instructions (only for PSX)
Press knob once to display the current DMX Address
Changing DMX Address
- ress knob twice to change the DMX address.
- While the screen is flashing, turn the knob to change the DMX address.
- Press knob once to save (DMX address will automatically save after 5s of inactivity)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
DMX Terminator Mode
To toggle the built in DMX terminator, press the knob once to illuminate the
screen, then press and hold for 5s until “On” or “Off” is displayed. Use this
in the last light of the installation to reduce signal noise issues.
1689 Regatta Blvd., Richmond, CA 94804 |
Kessil@Kessil.com
510-620-5250
Documents / Resources
|
Kessil W360 Outdoor Landscape
Light
[pdf] User Guide
W360, W500, W360 Outdoor Landscape Light, Outdoor Landscape Light, Landscape
Light, Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>