Kessil DMX Track LED Light Panel User Guide
- June 4, 2024
- Kessil
Table of Contents
Kessil DMX Track LED Light Panel
VIDEO LINKS
STEP-BY-STEP INSTRUCTIONS
Please refer to the listed QR Code/Links for detailed step-by-step
instructions for the wiring cable per installation requirements. Contact
design@kessil.com for more information.
INSTRUCTIONS
READ AND SAVE ALL INSTRUCTIONS
- Disconnect electrical power before adding to or changing the configuration of the track.
- Do not install this track in damp or wet locations (IP20, 45°C max).
- Do not install any part of a track system less 5 ft. above the floor.
- Check with a qualified electrician prior to any installation.
- Do not attempt to energize anything other than lighting track fixtures on the track.
- In order to reduce the risk of fire and electrical shock, do not attempt to connect power tools, extension cords, appliances and the like to the track.
- Do not slide light fixtures along the track when relocating. Always remove the fixture/adapter from track.
- Before reinstalling in new location, make sure to properly secured the adapter back in track.
Wire Power to End Feed
Each End Feed component has two (2) sets of 20A-max conductors for two (2) individual power circuits.
Line drawing of power splicing on End Feed
Legend
- A 233 Series, 2 Circuit 120V Track
- B Securing screw for end feed component
- C DMX/Data conductor entry
- D Power conductor entry for Circuit 1 and Circuit 2
End feed Component with pin-outs
Wire DMX to End Feed
DMX signal requires 2 signal carriers and the polarity of the DMX conductors are labeled on the sticker located on the end feed component.
DMX Polarity Label Sticker
DMX Conductors wired to End Feed
Standard DMX Cabling and Polarity
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>