HANECO TRIPROOF20W06 TRIPROOF YG Weatherproof Batten Installation Guide

LED BATTEN INSTALLATION GUIDE
TRIPROOF SERIES

TRIPROOF20W06 TRIPROOF YG Weatherproof Batten

Thanks for choosing our TRIPROOF batten series products.
We strongly recommend that you read this manual carefully before installation.
WARNING

• The luminaire must be installed by professional electrician.
• Switch power off when wiring the luminaire.
• Ensure input voltage conforms to the voltage range of product.
• Ensure wires are securely connected.
• Before switching on, ensure that all the wiring is correct.
• The warranty is void if product is not installed according to the instructions.

Installation Instructions

1. Switch off power.
   Isolate the electrical supply near location so as not to cause electrical hazard.

2. Measure hole positions on mounting surface.
   Fasten brackets to mounting surface.

3. Release clips on side of fitting and remove diffuser.

4. Knock-out or cut out holes as necessary to install cables.

5. Unlock and remove gear tray.

6. Wire as shown.*

7. For Intellisensor models, see attached leaflet for setup guide.
   Ecoswitch models got to step 8. All other models go to step 9.

8. Toggle switch left for 40W output.
   Toggle switch right for 20W output.

9. Replace gear tray and diffuser.
   Fasten anti-vandal screws if required.

10. Clip fitting onto brackets.

11. Test the installation in accordance with the wiring rules and regulation. Switch on power. * Wire as shown for EMDD and DALI models

For more information
www.haneco.com.au
1300 001 LED Last updated 27/06/23

Documents / Resources

| HANECO TRIPROOF20W06 TRIPROOF YG Weatherproof Batten [pdf] Installation Guide
TRIPROOF20W06 TRIPROOF YG Weatherproof Batten, TRIPROOF20W06, TRIPROOF YG Weatherproof Batten, YG Weatherproof Batten, Weatherproof Batten
---|---

References

• Haneco LED Lighting - Residential & Commercial Lighting | Australia

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>