OUKITEL WP20 Pro Smart Phone User Guide
- June 13, 2024
- OUKITEL
Table of Contents
OUKITEL WP20 Pro Smart Phone User Guide
User manual:
Individual parameters, description by figures and design in the manual may differ depending on the version and updates. Printing errors reserved. Update your device as soon as a new version of software is available. The warranty sheet and the user manual are included in the phone package.
Update your device as soon as a new version of software is available.
The buyer is obliged to provide a serial number on the warranty card as well as in the delivery note and the proof of purchase. In this context, the buyer acknowledges that unless the serial number of goods is not marked on the proof of purchase, delivery note and in the warranty card and therefore it cannot be possible to compare this serial number marked on goods and its protective packaging with the serial number stated in the warranty card, delivery note and the proof of purchase and thus to verify that the goods runs from the seller, the service center is competent to claim such a goods automatically and reject it immediately. The buyer must instruct all persons to whom the goods would be subsequently sold. Product complaints do with your dealer.
Safety use:
WP20 PRO has an increased resistance. However, it is not mechanically undestroyable. The display is made of tempered glass, which ensures higher resistence against scratches. When dropped on a hard surface or sharp object, it maycrack. The display cracked due to mechanical damage or improper misuse of the device is not covered by warranty.
The WP20 PRO has the IP68 certification under ISO 20653:2013 standard.
(According to producer 1,5 m depth for 30 minutes, IP68 resistance does not
apply to salt water.) The IP68 protection does not guarantee 100% resistance
to water in all conditions. We also recommend to not to charge the phone and
dry the phone´s connector after contact with water or other liquid with the
adequately warm air flow (up to 40°C). Always keep the input of the charging
jack tightly closed with cap when not charging the phone. The warranty is not
applied to an intentional damage to the phone.
Warning the microphone is located on the bottom of the phone, when
overlapped (eg with your hand), the other side will not hear or will hear very
poorly.
Installation of NANO SIM and microSD cards
Turn off your phone before installing cards.
- Carefully pull out the SIM or microSD card slot from the side of the phone using the SIM card eject clip. Then carefully pull it out of the buckle. Insert the cards into the slots until they click into its place, and put the slot back into the phone.
- It is possible to use 2x NANO SIM and 1x microSD card.
Charging the battery:
Before putting your phone into service you must recharge its battery for 100%.
- Connect the adapter to the charger. Please do not use violence, when plugging the connector.Keep plugging the USB-C connector from the correct side.
- Connect the charger to the wall outlet.
- If the battery is fully charged, disconnect the phone from the charger.
Switching the phone on / off / sleep mode
Make sure that the phone has a SIM card and the battery is fully charged. Press and hold the ON/OFF button to switch on the phone. Switch off the phone by pressing and holding ON/OFF button and select Power off, later OK. Press shortly ON/OFF button to switch the phone over to the sleep mode.
****Safety Precautions:
Do not use your phone while driving Do not use your phone at the petrol stations. Hold the phone at least 15 mm from your ear and body. The phone produces a bright or flashing light. The small parts of the phone can cause suffocation. Do not expose your phone to open fire. The phone can produce a loud sound. The phone is not resistant to fillings. Avoid exposure to magnetic fields. Keep the phone away from medical devices. On request, turn off your phone in hospitals and other medical facilities. Keep the phone dry. On request, turn off the phone at airports and on planes. Do not dismantle the phone. Turn off the phone in the vicinity of explosive materials and chemicals. Use the phone only with certified equipment. Do not reckon only upon your phone during emergency situations. The phone contains a label that detects moisture. In case of moisture inside phone this label becomes red. The manufacturer has the right to reject a warranty with such a damaged phone.
Damages requiring professional repair:
If such cases may occur, please, contact the authorized service or your
distributor: Moisture got into the phone. The phone is mechanically damaged.
The phone is extremely overheated.
- For household use: The given symbol (crossed-out wheeled bin) on the product or at accompanying documents means that used electrical and electronic products should not disposed of with household waste. To ensure proper disposal of the product, hand it over to a designated collection point, where it will be accepted free of charge. The correct disposal of this product will help to save valuable natural resources and prevent any potential negative impacts on the environment and human health, which could otherwise be caused by inappropriate disposal of wastes. For more details, please, contact your local authorities or the nearest collection point. The improper disposal of this waste can be penalized in accordance with national regulations. Information for users to disposal of electrical and electronic devices (corporate and business use): For proper disposal of electrical and electronic devices, ask for details from your dealer or distributor. Information for users to disposal of electrical and electronic devices in other countries outside EU: The above mentioned symbol (crossed-out wheeled bin) is valid only in the countries of EU. For proper disposal of electrical and electronic devices, ask for details from your authorities or dealer. All is expressed by the symbol of crossed-out wheeled bin on product, packaging or in printed materials.
- Set up the claim for warranty repair of device at your dealer. If you have technical questions or problems, contact your dealer. Follow the rules forwarding with electrical equipment. The user may not dismantle the device or replace any part of this. There is a warranty seal inside the phone to verify that the phone does not carry signs of improper intrusion. Opening or removing the covers poses the risk of electric shock. In case of incorrect reassembly and subsequent connection you are also exposed to electric shock.
Declaration of Conformity:
Company INTELEK.CZ s.r.o. hereby declares that all WP20 PRO devices are in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available on this website www.intelek.cz or www.oukitel.eu
The warranty period of the product is 24 months, unless stated otherwise.
This device can be used in the following countries:
AT | BE | CY | CZ | DK | EE | Fl | MT | NL | PL | PT | SK |
---|---|---|---|---|---|---|---|---|---|---|---|
SI | ES | DE | GR | HU | IE | IT | LV | LT | GB IS LI | ||
NO | CH | BG | HR | RU | RO | FR | SE | LU |
Restrictions on WiFi use
| IT
---|---
NO
Italy : The conditions for using the WiFi network are described in the
so-called Electronic Communications Code
Norway: The 2.4 GHz limitation applies only to the area 20 km from colony
of Ny-Ålesund.
RoHS: The components used in the device meet the requirements on the
restriction of hazardous substances in electrical and electronic devices in
accordance with Directive 2011/65/EU. The RoHS declaration can be downloaded
from www.intelek.cz or
www.oukitel.eu
Operation of radio equipment:
CZ: This radio equipment can be operated in the Czech Republic under the
General Authorizations VO-R / 1 / 05.2017-2 and VO-R / 12 / 09.2010-12.
SK: This radio equipment can be operated underGeneral Authorizations VPR
– 07/2014, VPR – 02/2017 and VPR – 35/2012.
Maximum EIRP:
Max. 2 W
Frequency range:
- GSM: 2100/1900/850/900 MHz
- WCDMA: 2100/1900/850/900 MHz
- LTE: 2100/1800/2600/900/800 MHz
- 2.4G WiFi (20 MHz): 2412 – 2472 MHz
- 2.4G WiFi (40 MHz): 2422 – 2462 MHz
- 5G WiFi: (20 MHz) 5180 – 5320 MHz
- 5G WiFi: (40 MHz) 5190 – 5310 MHz
- 5G WiFi: (80 MHz) 5210 – 5290 MHz
Google, Android and Google Chrome are trademark Google LLC.
Manufacturer:
Shenzhen Yunji Inteligent Technology CO.,LTD
A-Side A2 Building 2/F Enet New Industrial park, No. 20 Dafu Industrial Zone,
Aobei Community, Guanlan, Longhua New District, Shenzhen China
Exclusive importer of Oukitel products to EU:
Headquarter: INTELEK.CZ s r.o., Olivova 2096/4, Nové
Město (Praha 1), 110 00 Praha, CZ
Branch: INTELEK.CZ s r.o., Ericha Roučky 1291/4, 627 00
Brno, CZ
WEB: http://www.oukitel.eu
SUPPORT: http://www.oukitel.eu/helpdesk
Copyright © 2023 INTELEK.CZ s r.o.
All rights reserved.
References
- KOMPONENTY DATOVÝCH A TELEKOMUNIKAČNÍCH SÍTÍ | Intelek
- iGET chytré zabezpečení a spotřební elektronika
- OUKITEL odolné a mobilní telefony
- OUKITEL odolné a mobilní telefony
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>