CYCMOTOR X6 Controller Extension Wire and Mount Installation Guide
- June 13, 2024
- CYCMOTOR
Table of Contents
CYC X6 CONTROLLER
EXTENSION WIRE & MOUNT
INSTALLATION GUIDE
support@cycmotor.com
+852 3690 8938
Requirements
To install the extension wire & mount, you will need the following components:
- 4x M5X10 Bolts
- 4x M3X6 Bolts
Please note that the sptes and images used in the below guide are for reference only. We strongly encourage you to email technical_support@cycmotor.com if you are uncertain about any of the steps described below.
Installation Guide
STEP 1: INSTALL THE CONTROLLER MOUNT
Place the controller into the mount & tighten the four bolts on the controller
mount.
STEP 2: ASSEMBLE THE
EXTENSION PIECE
Install the clamp onto the extension piece & tighten the bolt accordingly.
Put the two spacers into the two gaps of the extension piece’s top respectively. Use a tool to adjust the hole and adjust accordinly so the circluar parts are aligned for the long screw to go through.
Insert the long screw to have it go through the right plate first and one- piece cyclinder, then carefully when inserting through the extension piece. Afterwards, complete the insertion through the left plate and tighten the screw.
STEP 2: INSTALL BOTH THE MOUNT & EXTENSION PIECE
Lastly, combine the mount & extension piece by tightening the four bolts
accordingly and you’re good to go!
Kindly contact technical_support@cycmotor.com if further assistance is needed. Thank you!
© 2022 CYCMOTOR LTD
Documents / Resources
|
CYCMOTOR X6 Controller Extension Wire and
Mount
[pdf] Installation Guide
X6, X6 Controller Extension Wire and Mount, Controller Extension Wire and
Mount, Extension Wire and Mount, Wire and Mount, Mount
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>