CYCMOTOR 18112022 Controller Extension Wire and Mount Installation Guide

June 9, 2024
CYCMOTOR

CYCMOTOR 18112022 Controller Extension Wire and Mount Installation Guide

To install the extension wire & mount, you will need the following components:

  • 4x M5X10 Bolts
  • 4x M3X6 Bolt

Please note that the sptes and images used in the below guide are for reference only. We strongly encourage you to email technical_support@cycmotor.com if you are uncertain about any of the steps described below.

Contents

Contents

INSTALL THE CONTROLLER MOUNT

Place the controller into the mount & tighten the four bolts on the controller mount.

Install The Controller Mount

ASSEMBLE THE EXTENSION PIECE

Install the clamp onto the extension piece & tighten the bolt accordingly.

Assembly Instruction

Put the two spacers into the two gaps of the extension piece’s top respectively. Use a tool to adjust the hole and adjust accordinly so the circluar parts are aligned for the long screw to go through.
Assembly Instruction

Insert the long screw to have it go through the right plate first and one- piece cyclinder, then carefully when inserting through the extension piece. Afterwards, complete the insertion through the left plate and tighten the screw.
Assembly Instruction
Assembly Instruction

INSTALL BOTH THE MOUNT & EXTENSION PIECE

Lastly, combine the mount & extension piece by tightening the four bolts accordingly and you’re good to go!

Installation Instruction

Kindly contact technical_support@cycmotor.com if further assistance is needed. Thank you!

  support@cycmotor.com
+852 3690 8938

CYCMOTOR Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals