maytronics ULTIMATE Robotic Pool Cleaner User Guide

maytronics ULTIMATE Robotic Pool Cleaner

ULTIMATE

Cautions & Warnings

• Use the originally supplied power supply only.
• Do not use an extension cable in any case whatsoever.
• Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth leakage interrupter
• Ensure that the power supply is not in a wet environment.
• Do not enter the pool while the pool cleaner is in the water.
• Unplug the power supply before servicing.
• Do not use the cable to take the pool cleaner out of the water.
• Use the Pool Cleaner in the following water conditions only: Chlorine Max 4 ppm; pH 7.0 – 7.8; Temperature 6 -34°C (43-93°F); NaCI Maximum = 5000 ppm.

 Recommendation

• The power supply should be placed in a well ventilated and shaded location.
• If the Dolphin is fitted with combined or wonder brushes, gently squeeze the brushes until they are soaked with water and only then start the cleaning process.
• Release minimal required floating cable length to ensure proper pool coverage. Leave excess cable rolled outside the pool.
• After each cleaning cycle wash the filters or cartridge. Clogged filters reduce scanning and cleaning efficiency.
• In case the cable has some kinks, stretch it out completely and let it sit for at least a day in the sun.
• Store the pool cleaner in a shady place on the caddy.
• After each cleaning cycle wash the filters or cartridge. Clogged filters reduce scanning and cleaning efficiency
•  In case the cable has some kinks, stretch it out completely and let it sit for at least a day in the sun.
• Store the pool cleaner in a shady place on the caddy.

Operating the robot using the Dolphin™ Plus app

• Plug in the power supply.
• Download the Dolphin™ Plus app.
• Activate Bluetooth® and Wi-Fi® on your smart device.
• Start the registration process.
• Scan the QR code printed on the power supply, and complete the process.
• Follow the instructions as showed in the app.

Thank you for purchasing a Micronics  Dolphin Robotic Pool Cleaner

The Robotic Pool Cleaners by Medtronic’s deliver advanced cleaning technologies, long lasting performance and easy maintenance. You and your family will be free to enjoy swimming with full confidence that your pool is completely clean.

Robot operation

Position the power supply at least 3.5m/12ft away from the edge of the pool.

In to the pool

Put the pool cleaner in the pool and let it sink to the floor. Make sure that the floating cable is free of any obstructions.

Operation

Turn the power supply ON. The pool cleaner will now operate until it has reached the end of the cleaning cycle.

Out of the pool

Use the robot’s handle to pull it out from the pool.

Cleaning the filter

It is highly recommended to clean the filter basket after each cleaning cycle. Note: Don’t let the filter cartridges dry out before cleaning. A Unplug the power supply before servicing 6с

Open the latch to release the bottom lid in order to remove the debris.

Storage

Coil the cable and store in a cool, dry place. Do NOT store the robot and its accessories where it will be exposed to direct sunlight, excessive heat or to frost.

Maintenance

Periodic filter

cleaning Dismantle the 4 ultra-fine filter panels of the outer basket according to the following steps.

Hold down the handle and remove the inner net.

Dismantle the panels, starting with pressing on panel no.1 using your thumbs.

Continue to dismantle the panels in the order of their numbers: no.2–> о.3–> no.4.

Cleaning the impeller

If you notice debris trapped in the impeller: Unplug the power supply before servicing Clean the debris trapped in the impeller opening, according to the following steps.

For a detailed manual (including videos).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>