CYCMOTOR X6 Controller Upgrade Kit User Guide

June 9, 2024
CYCMOTOR

CYCMOTOR X6 Controller Upgrade Kit

CYCMOTOR-X6-Controller-Upgrade-Kit-PRO

Requirements

To upgrade from the ASI BAC855 to the CYC X6 Controller, the follow components are required for conversion:

  • X6 Controller
  • Wire Cover Plate
  • Bluetooth Speed Sensor & Magnet
  • Speed Sensor Magnet
  • SW102/ DS103 Display (optional)

Please note that the sptes and images used in the below guide are for reference only. We strongly encourage you to email technical_support@cycmotor.com if you are uncertain about any of the steps described below.

CYC X6 Controller Upgrade Kit Guide

  1. STEP 1:
    Unplug the phase wires (yellow, blue, red), torque sensor wire, motor wire & XT90 connector from the BAC855 controller mount.

  2. STEP 2:
    Unscrew the BAC855 controller mount bolts from both sides and remove the controller & controller mount to install the X6 controller.CYCMOTOR-X6
-Controller-Upgrade-Kit-2

  3. STEP 3:
    Plug in the phase wires (yellow, blue, (green = red)) & insert the torque sensor wire, motor wire, XT90 connector at the back of the controller mounting plate.CYCMOTOR-X6-Controller-Upgrade-Kit-3

  4. STEP 4:
    Gently bend all the wires, and the house them inside the controller housing, then tighten all the bolts on the controller mount.CYCMOTOR-X6-Controller-
Upgrade-Kit-4
    And finished! As mentioned prior, kindly contact technical_support@cycmotor.com if further assistance is needed. Thank you!.

  5. STEP 5:
    Tighten the bolts according to the kit you have as follows. (X1 Pro, M5 Bolts = red circle, X1 Stealth, M4 Bolts = green circle). CYCMOTOR-X6-Controller-Upgrade-Kit-6

support@cycmotor.com
+852 3690 8938

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals