EUROfase 39331 Natalia Black Bath Bar Instruction Manual
- June 13, 2024
- EUROfase
Table of Contents
EUROfase 39331 Natalia Black Bath Bar
Product Information
You have purchased a lighting product that is designed to provide you with years of enjoyment.
Product Specifications
- Model Number: 39331
- Maximum Bulb Wattage: 4x60W
- Bulb Type: B10
- Power Supply: 120V, 60Hz
- Bulbs: Not included
Product Usage Instructions
Before starting the assembly process, make sure you have the following tools:
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
Helpful tools (not included) that you may also need:
- Wire strippers
- Ladder
Estimated Assembly Time: 20 minutes
Follow these steps to assemble and install your lighting product:
- Start by securing the A-Outlet Box screws (2 screws) to the junction box.
- Connect the Black wire (L) from the junction box to the Black wire (L) from the fixture (E).
- Connect the White wire (N) from the junction box to the White wire (N) from the fixture (F).
- Connect the Green wire/Bare copper (G) from the junction box to the Green wire/Bare copper from the fixture (G).
- Use the provided Wire connectors (3 connectors) to secure the connections.
Make sure all connections are secure and properly insulated with electrical tape. Once the assembly is complete, refer to the included user manual for instructions on how to operate and maintain your lighting product.
Note: For any future reference or troubleshooting, please keep these instructions for your convenience.
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
INSTALLATION
4x60W MAX, B10, 120V 60 Hz (Bulbs not included) 
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Thank You: You’ ve just purchased a lighting product designedand built to provide you with years of enjoyment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>