Baseus V40091W TWS Earbuds with Charging Box Instruction Manual
- June 12, 2024
- Baseus
Table of Contents
type-C charging cable
Wireless Earphones
With Charging case
TWS EARBUDS WITH CHARGING BOX
Model:V40091W FCC ID:2BB3B-V40091W
Instruction Manual
V40091W TWS Earbuds with Charging Box
Powering On/ Bluetooth Pairing
(When the earbuds are not in the charging box) Press & hold both
power buttons simultaneously for 2-3 Seconds 
One earbud blue and red light
flashes alternately, another ear bud with blue light flash every 5
seconds
Check your phone’s Bluetooth settings menu. Make
sure that Bluetooth is turned ON. Connect with the device listed as V40093W .
Controlling Your Earphones
One Click: Play/Pause/Answer Incoming Call/End Call Long press for 2
seconds: Activate Siri/Google Voice Assistants Long press for 2 seconds:
Reject an Incoming Call Hold 3-4 Seconds: Power Off (When Not Recieving a
Call) Previous song: Double click on left ear
Next track: Double click on the right ear
Click: answer/hang up the phone
Click: Play Pause
Long press for 2 seconds: Voice assistant, short press to exit
Long press for 2 seconds: reject incoming call
Press and hold for 4 seconds to shut down
Press and hold for 2 seconds to turn on the device 4. Label
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
5. User manal
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>