EUROfase 39465 Barletta 16 Light LED Chandelier Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EUROfase 39465 Barletta 16 Light LED Chandelier
Product Information
- A-Outlet Box screw x 2
- B-Black wire(L) from junction box
- C-White wire(N) from junction box
- D-Green wire/Bare copper (G) from the junction box
- E-Black wire (L) from the fixture
- F-White wire (N) from the fixture
- G-Green wire/Bare copper from the fixture
- H-Wire connector x 3
Product Usage Instructions
- Start by attaching the A-Outlet Box screws to the outlet box using the provided screws. Make sure they are securely fastened.
- Identify the B-Black wire (L) from the junction box and connect it to the corresponding black wire (L) from the fixture. Use a wire connector (H) to join them together. Make sure the connection is tight and secure.
- Locate the C-White wire (N) from the junction box and connect it to the corresponding white wire (N) from the fixture. Again, use a wire connector (H) to make the connection.
- Find the D-Green wire/Bare copper (G) from the junction box and connect it to the corresponding green wire/Bare copper from the fixture. Use a wire connector (H) to securely join them together.
- Ensure that all connections are properly insulated and there are no exposed wires.
- Once all the connections are made, carefully tuck any excess wires into the outlet box.
- Double-check all connections to ensure they are secure and tightly connected.
- Follow any additional instructions provided in the user manual for the final installation and testing of the product.
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical order.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL certified wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters. Helpful Tools (not included): Wire strippers, Ladder
INSTALLATION
Note: Press the wire restraint to adjust the desired length of cable.
- A- Outlet Box screw × 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector × 3
THIS LUMINAIRE MUST BE MOUNTED OR SUPPORTED INDEPENDENTLY OF AN OUTLET BOX
DIMENSION
- 90W MAX 120V, 60 Hz (Dimmable LED Included)
Thank You: You’ve just purchased a lighting product designed and built to provide you with years of enjoyment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>