Eurofase 38143 Tura 3 Light Pendant Instructions
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 38143 Tura 3 Light Pendant
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoyment.
Product Information
- Product Model: 38143
- Product Type: Lighting
- Power: 3 x 60W MAX, B10, 120V, 60Hz (Bulb not included)
Product Usage Instructions
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Helpful Tools (not included): Wire strippers, Ladder
- Make sure to save these instructions for future reference.
- Follow the wiring diagram:
- A – Outlet Box screw x 2
- B – Black wire (L) from junction box
- C – White wire (N) from junction box
- D – Green wire/Bare copper (G) from junction box
- E – Black wire (L) from fixture
- F – White wire (N) from fixture
- G – Green wire/Bare copper from fixture
- H – Wire connector x 3
- Refer to the user manual for specific instructions on connecting the wires to the outlet box and the fixture.
- Once the wiring is complete, install the bulbs (not included) according to the maximum wattage and type specified.
- After assembly, test the lighting product to ensure it is working properly.
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE:
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together.
- If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools
Tools Required For Assembly (not included): Flathead screwdriver,
Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
Helpful Tools (not included): Wire strippers, Ladder
INSTALLATION
3 X 60W MAX,B10,120V,60Hz (Bulb not included)
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>